1.
Secondary Development of SolidWorks Based on VC++ Realize Gear Shaft Design
基于VC++的Solidworks二次开发技术研究及齿轮轴参数化设计的实现
2.
Influence of Parameter Matching of Gear Coupled Rotor System on Imbalance Response
齿轮轴系参数匹配对系统不平衡响应的影响
3.
Influence of impeller parameters on the performance of 020Q84 water jet axial flow pump
叶轮参数对020Q84喷水推进轴流泵性能的影响
4.
The machine is suitabe for largebatch, small batch and single production of cylindrical spur and helical gears worm gears sprocket and spline shaft in certain range of parameters.
*该机床适用于成批、批及单件生产加工圆柱直齿轮、柱斜齿轮、轮和一定参数的花键轴。
5.
Numerical Simulation Analysis of Shaft Orbit for Hydraulic Generator Set;
水轮机主轴轴心轨迹的数值仿真分析
6.
Mark the propeller shaft and pinion yoke, or pinion flange, for installation reference.
在传动轴和传动轴轴轭、或小齿轮轴轭上作标记，作安装的参考标志。
7.
Spline shaft grinding machines-Parameters
GB/T10930-1989花键轴磨床参数
8.
Refer to Drive Pinion Bearing Pre-Load Adjustment.
参阅驱动小齿轮轴承预荷调整。
9.
Discussion on the Hydraulic Parameters of Bearing Prong in Long-axial Pump for Deep Well;
长轴深井泵轴承支架水力参数的探讨
10.
Development of the Data Processing Software for Cam Grinding Machine Based on 840D CNC
840D数控凸轮轴磨床数据处理软件开发
11.
An Three-dimentianal Numerical Turbulent Flow Simulstion for Rim Clearance of Kaplan Turbine
轴流式水轮机轮缘间隙三维紊流数值模拟
12.
camshaft(journal )turning lathe
凸轮轴（轴颈）车床
13.
fine pitch automatic pinion shaft hobbing machine
小模数轴齿轮自动滚齿机
14.
A Method of Machining Camshaft by Reconstructing Model XJK 325-2Nc Milling Machine;
改造XJK325-2型数控铣床加工凸轮轴
15.
Design of the crankshaft pulley signal plate dedicated CNC milling machine
曲轴皮带轮信号盘数控铣齿专机设计
16.
Five-axis Machining Simulation of Integral Impeller Based on VERICUT
基于VERICUT的整体叶轮五轴数控加工仿真
17.
overhead cam shaft
上凸轮轴上部凸轮轴
18.
Programming of Inner-milling of Crankshaft Drive Spindle with Parameters R
基于R参数的曲轴主轴颈内铣加工循环编程