1.
The Excessive Maintenance of Bearing and the Field Treatment of Dynamic Balance in High Temperature Fan
高温风机轴承过维修与动平衡的现场处理
2.
Crankshaft and main bearings service
曲轴和主轴承的维修
3.
"They must not be mixed during any service job, since this could result in poor bearing fit and bearing failure."
"在维修过程中,千万不能弄混,因为这会造成轴承不配套及轴承的损坏。"
4.
"This section describes the servicing of crankshafts, main bearings, and engine Blocks and cylinders."
本节介绍曲轴、主轴承、发动机机体和气缸的维修。
5.
If the axle shaft and hub bearing are being removed in order to service another component, the axle shaft and hub bearing can be removed as an assembly.
如果维修时需拆卸主动轴和轮毂轴承，主动轴和轮毂轴承可作为一个总成加以拆卸。
6.
Superfinishing of Bearing Rollers and 3D Simulation of Surface Topography;
轴承滚子超精密修形及表面三维形貌模拟
7.
Discussion on the Maintaining Parameters of Mine-used Rolling Bearing and Its Count Method
矿用滚动轴承维修参数及计算方法探讨
8.
Study on fault of marine auxiliary propulsive bearing and analysis to the maintaining technique
某型辅助船推力轴承故障研究与维修技术浅析
9.
CONDITION MAINTENANCE OF YL_Ⅱ TYPE FLUE GAS TURBINE AND TECHNICAL REPAIRING OF THRUST BEARING PADS
YL_Ⅱ型烟气轮机状态维修及止推轴承瓦块修复技术
10.
"Valve Service and Maintenance includes installing new seat inserts, cleaning or replacing valve guides, servicing the camshaft and camshaft bearings, and timing the valves."
气门维修包括镶配气门座,清洁或更换气门导管,保养凸轮轴和凸轮轴轴承,气门的正时调整。
11.
Analysis of Common Inspection and Repair of 353130B Bearings
353130B型轴承一般检修分析
12.
Front A rotation on balls bearings and needles, hydraulic clamping on crown type, reached and maintained position sensors, hydraulic control, control as M Function.
A面采用滚珠滚针轴承，冠状液压夹具，维修定位传感器，液压系统。
13.
Large Slew Bearing Condition Based Maintenance and Emulation Research about Best Testing Periodic Time;
回转大轴承的状态维修及其最佳检测周期仿真研究
14.
The major enemy of good work is dirt. A trace of dirt left on a bearing or cylinder wall would ruin an otherwise good job.
高质量维修工作的最主要问题是油污。残留在轴承或是气缸壁上的油污会影响维修工作的质量。
15.
Reasons Analysis and Maintenance Measures for the Failture of Converter Trunnion Bearing
转炉耳轴轴承的故障分析和维护措施
16.
Excessive friction in strut upper bearing
支柱上轴承磨损过度
17.
bearing over-heat protective relay
轴承过热保护继电器
18.
Many bearing difficulties can be taken care of by this method of bearing replacement.
许多轴承故障能够通过更换主轴承或轴承来解决。