1.
Segmental mechanical analysis of TBM under pushing force of fuel tank
TBM辅助油缸推力下的衬砌管片受力分析
2.
Analysis of Lateral Thrust on Main Cylinder Rod of Hydraulic Swing Beam Shear on the Basis of Finite Element Analysis
液压摆式剪板机主油缸活塞杆侧推力有限元分析
3.
There are four(4) side launching arrangements and two(2) longitudinal launching arrangements positioned on the brackets, plus two(2) side launching cylinders placed on the“ horns” of the suspension gallow.
牛腿上共设4台横向推进油缸，2台纵向推进油缸，此外，在吊架牛腿上设有2台横向推进油缸。
4.
Research on Measuring Method of Maximum Cylinder Compression Pressure for Multi-cylinder Diesel Engine
多缸柴油机最大气缸压缩压力测试方法研究
5.
Multi-body System Dynamics Simulation of Crankshaft System in a Four Cylinder In-line Diesel Engine
直列四缸柴油机轴系动力学仿真分析
6.
Each separate arrangement consists of one (1) pump unit connected to two (2) double acting side-launching cylinders and one (1) double acting launching cylinder.
每台系统包括1台油泵连接2台双向液压油缸和一台双向液压推进油缸。
7.
Analysis on the Relationship Between Rise Rate of Cylinder Pressure and Combustion Noise
车用柴油机气缸压力升高率与燃烧噪声的关系
8.
The Research on Cylinder Pressure Reconstruction by Impulse and Response Signals in Diesel Engine;
冲击响应信号反演柴油机气缸压力的研究
9.
Analysis of Thermal-Mechanical Coupling Stress of Aluminium Alloy Cylinder Head
铝合金柴油机气缸盖热-机耦合应力分析
10.
EEB 5L Six Cylinder SOHC Gasoline
EEB5L六缸SOHC汽油
11.
C 0L 4 Cyl 16V Gasoline SOHC
C0L4缸16V汽油SOHC
12.
Each Supporting Bracket is equipped with two(2) transverse cylinders, connected between the Launching Wagon and the Supporting Bracket.
每个牛腿安装2个横向油缸连接到推进工作车上。
13.
"Fuel injection: In an internal-combustion engine, introduction of fuel into the cylinders by a pump rather than by the suction created by the movement of the pistons."
燃油喷射:用泵而不靠活塞运动产生的吸力将燃油喷入内燃机汽缸。
14.
Special drastic replacement rings will control compression and oil in cylinders with some taper and out-of-round wear.
在这种情况下,特别精选的油环有助于控制气缸的压力和油耗。
15.
steam-refined cylinder stock
汽炼汽缸油,重(润滑)油
16.
compensating master cylinder
带补偿贮油槽的主油缸
17.
hoist cylinder oil relief valve
起重机油缸油压安全阀
18.
The Calculation and Control of Inertia Forces and Additional Moments of a Singular Balancing Shaft in a Small Single Cylinder Diesel Engine
小型单缸柴油机单轴平衡时惯性力和附加力矩的计算与控制