1.
The design of a support with eccentricity for turning high-power 9 cylinders diesel engine crank pin
大型9缸柴油机曲轴连杆轴颈车削偏心扶架设计
2.
Kinematic Precision Analysis on Crankshaft Neck of Compound Follow-up Turning System
曲轴连杆颈复合跟随车削系统的运动精度分析
3.
Dynamical Analysis and Optimization on Crankshaft Neck of Compound Follow-up Turning Cutter Frame
曲轴连杆颈复合跟随车削刀架的动力学分析与优化
4.
axle journal turning and burnishing lathe
轴颈车削及抛光车床
5.
Abstract: The article introduced a grinding method and principle of the journal of crankshaft connecting rod.
本文简述了一种正在兴起的曲轴连杆轴颈的磨削方法和原理。
6.
Disconnect stabilizer bar links at the axle.
断开车轴上稳定杆连杆。
7.
A pole connecting the rear axle of a vehicle with the front.
连接杆连接车辆前后轴的杆
8.
Remove piston and connecting rods from crankshaft journals.
从曲轴颈上拆下活塞和连杆。
9.
crankshaft journal milling machine
曲轴轴颈铣削专用机床
10.
crankshaft (main journal turning lathe)
曲轴（主轴颈）车床
11.
camshaft(journal )turning lathe
凸轮轴（轴颈）车床
12.
Four Axis-Interplation Grinding and Turning Method of Planar Double-Enveloping Worm Study
平面二次包络蜗杆的四轴四联动磨削和车削方法研究
13.
CAE Analysis of Crankshaft and Connecting Rod Mechanism for Motorcycle Engine
摩托车发动机曲轴连杆机构的CAE分析
14.
The main bearing journals fit into the cylinder block and the big end journals align with the connecting rods.
主要轴承曲颈安装在气缸体和与连杆大头末端匹配的曲颈上。
15.
"The connecting rod carries the power thrusts from the piston to the crankpin. At the same time, the rod is in eccentric motion."
"连杆的作用是将活塞承受的压力传给连杆轴颈。同时,连杆做偏心运动。"
16.
Dynamic Analysis and Simulation of the Automotive Air Compressor's Crank-Rod Mechanism
车用空压机曲轴连杆机构的动力学分析与仿真
17.
The rod-bearing cap attaches the connecting rod to the crankpin.
连杆轴瓦盖将连杆安装到曲轴销上。
18.
The long, tapering wooden shaft extending up from the front axle of a vehicle to the collars of the animals drawing it;a tongue.
车辕从一辆车的前轴延伸到牵引该车的动物身上所套颈圈上的一根长的、由粗变细的木杆；辕杆