1.
Research and Development of the Electromagnetic-Hysteresis Yarn Tensioning Device
电磁式磁滞纱线张力器的研究与开发
2.
Tension devices to help maintain uniform tension throughout the creel, guides to direct the yarn and to help keep the ends apart
张力装置使所有的纱线保持均匀的张力；导纱器用来引导纱线并使纱线分开；
3.
Methods of Yarn Pulling and Yarn Tension's Stabilization in Carpet Tufting Machine
地毯簇绒机纱线牵引和张力稳定方法
4.
Each end has to be controlled, therefore one tension device per end is needed.
每根纱线都应单独控制,因此每根纱线都需要一个张力装置。
5.
Development of testing system of warp tension based on optical fiber force sensor
基于光纤力传感器的经纱张力测试系统
6.
At high winding speeds, due to inertia, the rotation of the spool may lead to tension variations in the yarn.
在高速络纱时,由于惯性作用,筒子的回转会导致纱线张力的波动。
7.
These breakage could be the result of excessive tension or, perhaps, a weak spot in the yarn.
断头的原因可能是经纱张力过大或纱线中存在弱段。
8.
The Research of Ring Spinning Theory Based on Balloon Shape and Yarn Tension;
基于气圈形态与纱线张力的环锭纺理论研究
9.
Non-contact dynamic measurement of yarn tension in winding process
非接触式纱线卷绕张力动态检测方法的研究
10.
Application of Magnetostrictive Pick-up to Constant Tension Control of Warp;
织机恒经纱张力控制中磁致伸缩传感器的应用
11.
To help maintain uniform tension in the filling yarns
有助于纬纱张力的均匀。
12.
The yarns must be parallel and under uniform tension. This, then, is the purpose of warping.
纱线必须相互平行,且张力均匀,这就是整经的目的。
13.
Effect of filament pre-tension on performance of wool/polyester embedded composite yarn
长线预加张力对毛涤嵌入式复合纺成纱性能的影响
14.
Also, upon start -up, higher tension are developed because the winder must overcome spool inertia.
另外,在络纱机启动时,由于需要克服筒子的惯性,会产生较大的纱线张力。
15.
The yarn is directed into this zone by a guide.
纱线通过导纱器进入此区。
16.
The tensions are not high and it is usually sufficient to apply just enough to prevent the yarn snarling and entangling.
张力不宜过高,通常在不产生纱线扭结和纠缠的情况下,尽可能采用较小的张力。
17.
Uses the sourceless magnetic damping tensor to control winding tension.
绕线张力控制采用无源磁阻尼张力器控制。
18.
test method for breaking strength of yarn and thread;skein method
纱线的断裂强力试验法：绞纱法