1.
Choice of Main Bearing of Cutting Part for Longitudinal Roadheader
纵轴式掘进机截割部主轴承的选型分析
2.
perpendicular cut
(与轴成)垂直(截面)截割
3.
Research on the Dynamic Property of the Drive System of Transverse Roadheader's Cutting Unit
横轴式掘进机截割部传动系统动态特性研究
4.
MAIN BEARING JOURNAL DIAMETER (CRANKSHAFT REMOVED)
主轴承颈部直径（曲轴已卸去）
5.
Checking Parameter and Optimizing Design to Selective Cross Shaft Road Header Cutting Head Design;
部分断面横轴悬臂式掘进机截割头设计参数的验算与优化设计
6.
upper center crankshaft bearing
曲轴主轴承上中轴瓦
7.
The main components of a spider cardan joint include the spider, yokes and quill bearings, etc.
其主要部件包括十字轴、向节叉以及滚针轴承等。
8.
Transverse Roadheader Cutting Head Simulation and Optimized Design;
横轴式掘进机截割头仿真及优化设计
9.
Simulation and Analysis of Loads on Cutting Head of Horizontal Roadheader
横轴式掘进机截割头载荷的模拟分析
10.
The feed holes for the crankshaft main bearings.
曲轴主轴承进入口。
11.
Crankshaft and main bearings service
曲轴和主轴承的维修
12.
Install the lower bearing inserts into the main bearing caps.
安装下轴瓦到主轴承盖。
13.
Calculation of Bearing Capacity of Axial Compression Short Column with Round Cross-Section Reinforced by Enlarging Cross-Section Method
扩大截面加固轴心受压圆截面短柱承载力计算
14.
The Model Analysis of the Ceramic Bearing Electric Spindle;
陶瓷轴承电主轴主轴的振动模态分析
15.
Install axle shaft bearing with Installer 6436 and Handle C–417Ensure that the part number on the bearing is against the installer.
用安装工具6436和柄C–4171安装主动轴轴承。要保证轴承部件号码对着安装工具。
16.
Effect of axial compression ratio to bearing capacity of piece with T-shaped section
轴压比对T形截面构件承载力的影响
17.
These are the same as those used for the main bearings.
这些轴承与那些被用作主要轴承的轴承相同。
18.
Study on Design Automation Technique of Roadheader Cutting Head;
横轴掘进机截割头设计自动化技术研究