说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 句库 -> 摆动角度
1.
Different angles of high jump swinging leg to the influence of take-off;
背越式跳高摆动腿摆动角度对起跳效果的实验研究
2.
The Exsiting Problem and Improving Project In The Vividing Angle of Burner
摆动式燃烧器摆动角度灵活性存在问题和改进方案
3.
THEORY ANALYSIS ON ANGLE ACCURACY OF PERMANENT MAGNET SWING MOTOR SERVO SYSTEM
永磁摆动电机伺服系统转角精度的理论分析
4.
Study on feedback control of yaw angle rate based on active front steering
基于主动前轮转向横摆角速度反馈控制的研究
5.
When we make it longer, it vibrates more slowly.
金属杆越长,摆摆动的速度越慢。
6.
When we make the rod shorter, the pendulum vibrates faster.
金属杆越短,摆摆动的速度越快;
7.
Gas pendulum accelerometer and laminar jet angular rate gyroscope
气体摆式加速度计与射流角速度陀螺
8.
"When the two shafts are at an angle to each other, the bearings in the yokes permit the yokes to swing around on the trunnions with each revolution."
当两轴相互处在同一角度上,主动轴转动时万向节叉上的轴承使万向节叉绕万向节十字轴摆动。
9.
effective angle of obliquity
(转子发动机的) 有效摆动角
10.
Analysis of Kinematics and Dynamics in Variable Range Four-bar Linkage;
摆角可调机构的运动学及动力学研究
11.
Human Factors Analysis of Train Seat s Angle and Sickness;
列车座椅摆放角度与晕车的人因分析
12.
The act of oscillating.
摆动摇摆摆动的动作
13.
Output shaft when the swing set in the center of rotation on the trip-down, design may also need to set rotation angles and movements itinerary.
出力轴在摆动时可设定在旋转行程的中心点上停动,也可依设计需要设定旋转角度和升降行程。
14.
"Not only must the front wheels move up and down with respect to the car frame (for spring action), But also they must be able to swing at various angles to the car frame for steering."
前轮不仅要相对车架做上下运动(由于弹簧作用),而且在转向时能够相对车架做各种角度的摆动。
15.
horny rings on a rattlesnake's tail that make a rattling noise when shaken
响尾蛇尾部的角质环, 摆动时格格作响
16.
The balance wheel of a watch is a familiar example of angular harmonic motion.
钟表的摆轮是角谐运动的常例。
17.
A kind of swing thrust wheel triangular pedrail system introduction
一种摆动式支重轮三角履带轮系介绍
18.
Computer generates real time control command to drive motor controls displacement and up-down pendulum angle of hoist, its precise control is realized through this method.
由计算机产生实时控制指令驱动电机控制吊车位移、上下摆角,实现其精度控制。