1.
Design of on-load Tap-changer Control System Based on MCU
基于单片机的有载分接开关控制系统的设计
2.
Influence of the abnormal DC voltage fluctuation on transformer tap changer control
高压直流线路电压异常波动对分接开关控制的影响
3.
Tap-changing transformers also perform a voltage control function.
调节变压器的分接开关也可进行电压控制。
4.
The Research of SRM Direct Torque Control System
开关磁阻电机直接转矩控制系统研究
5.
Switched Reluctance Motor Direct Torque Control Based on Torque Share Function;
基于转矩分配函数法的开关磁阻调速电机直接转矩控制研究
6.
The Supervision and Control System of Short-Circuit Switch Based on Copper Electroanalysis PLC
基于PLC控制的铜电解用短接开关监控系统
7.
Disconnect the vacuum harness connector from the back of the heater-A/C mode control switch on the control panel.
从控制仪表板上的空调暖气模式控制开关上断开真空线束接头。
8.
Development of a New 10kV Solid On-Load Tap Changer;
新型10kV固体有载分接开关的研制
9.
Speed control switch input above the maximum acceptable voltage.
速度控制开关输入高于最大可接受电压。
10.
Speed control switch input below the minimum acceptable voltage.
速度控制开关输入低于最小可接受电压。
11.
Centralized Interlocking Monitoring System of OCS Isolating Switches
接触网隔离开关集中联锁监控系统的研制
12.
Research on Digital Control of Indirect Rotor Position Sensing for Switched Reluctance Motor;
开关磁阻电机间接位置检测的数字控制研究
13.
Research on Soft-Switching Digital Welding Power Source Based on DSP;
DSP控制的软开关数字化逆变焊接电源的研究
14.
The Fuzzy-PI Control for Direct Torque Control System of Switched Reluctance Drive System;
开关磁阻电机直接转矩模糊PI控制系统研究
15.
Direct Power Control of PWM Rectifier Based on New Switch Table
基于新型开关表的PWM整流器直接功率控制
16.
Soft switching control of high frequency induction welding power supply with PWM and PFM
高频感应焊接逆变电源PWM和PFM软开关控制
17.
Direct Torque Control for Permanent Magnet Synchronous Motor with Switch Table
基于开关表的永磁同步电机直接转矩控制
18.
Optimization of Switch Voltage of Direct Torque Control of Induction Motor
异步电动机直接转矩控制的开关电压优化