1.
Analysis and optimization of drawing process for interior car door panel
汽车门内板拉深成形工艺分析与优化
2.
The prediction and control on the springback of the front inner panel of automobile at multi-steps stamping
汽车前车门内板多步冲压成形回弹预测及控制
3.
Simulation Study on Forming Process for Automobile Inner Door Panel
轿车车门内板的成形工艺数值模拟研究
4.
Remove push-in fastener attaching trim cover to door inner panel (use special tool C-4829).
拆下把装饰盖板固定在车门内板的压入式钩扣（用特殊工具C-4829）。
5.
Research and development on 5754 aluminum alloy plate used on the door of sedan
轿车门内用5754铝合金板材的研发
6.
Disconnect the power mirror wire harness retainers from the inner door panel.
从内侧车门饰板断开电动视镜电线束扣件。
7.
Remove the trim panel from the front door.
从前车门上拆卸饰板。
8.
take one's foot off the throttle
脚离开（汽车的）油门踏板.
9.
Remove the door module from the trim panel.
从饰板上拆卸车门模组。
10.
Take one's foot off the throttle, ie off the accelerator, in a car
脚离开（汽车的）油门踏板
11.
"The interior lights include instrument panel lights, various warning, indicator, and courtesy lights which turn on when a car door is opened."
车内灯又包括仪表板灯、各种警告灯、指示灯和车门打开时自动开启的门控灯。
12.
Position the front door lower weatherstrip on the door inner panel aligning tape to bottom edge and press into place.
将前车门下部防水饰条移至车门内侧饰板上并将其与下边对齐，按压到位。
13.
Remove the glove box inner door panel from the glove box outer door panel.
从手套箱外门板上拆下手套箱内门板。
14.
"Such as the hood, the fenders, the roof panels, the door, the instrument panel, the Bumpers and the luggage compartment. "
例如,发动机盖板,挡泥板,车身顶板,车门,仪表板,汽车保险杠和行李箱。
15.
Side impact intrusion is minimised by the double-skinned floor construction, strong side sills and integral side impact bars in each door.
侧面的撞击经双层底板、强度的侧面门框和每个车门内部的防侧撞杆防护而降至最低。
16.
.(formerly)foot-board under the doors of a car
（旧时）汽车车门下方的踏板.
17.
Remove door inside handle actuator from door.
从车门上拆卸车门内侧手柄触发器。
18.
REAR DOOR INSIDE HANDLE ACTUATOR
后车门内侧手柄触发器