1.
Effect of Outside Welding Groove Angle on Weld Quality of X80 Grade SSAW Pipe
外焊坡口角度对X80级螺旋埋弧焊管焊缝质量的影响
2.
Research on Welding Gradient Optimization Process of 80kg Heavy Gauge Steel Plate in Hydraulic Support
液压支架用80kg级高强钢焊接坡口角度优化研究
3.
Study on Groove Shape and the Open Angle of End Tab of UOE Pipe;
UOE焊管坡口形状与引弧板开口角研究
4.
The old method of soldering metal sheets together has now been largely replaced by welted joints, which are made by a special efficient mechanical device.
搭接贴角焊接金属薄板的老方法,现今已基本上为对接坡口焊所取代。
5.
Indicates a weld in a flared-bevel groove. Stems will elongate when height is increased.
指示在喇叭形坡口焊接。杆可随着高度的增加而拉长。
6.
This consists for the most part in straightening up, cleaning, and, on thicker plates above 5/16 in vee-ing the edges.
主要是矫直，清选，对于厚度超过5／16 英寸的金属板，还需将焊边做成v形坡口。
7.
Study of Length Calculation of Three Side Welded Lap;
三面围焊搭接角焊缝长度计算的探讨
8.
Effect of Welding Angle on Fatigue Performance of Welded Structure
焊接角度对焊接结构疲劳性能的影响
9.
Both single and double fillet welds shall be as follows unless otherwise shown on the drawing.
除非图上另外标明，所有单、双面贴角焊缝高度如下。
10.
critical slope angle [transport]
最大安全斜坡角度〔交通〕
11.
THE MATCH RELATIONS BETWEEN SUNRISE AND SUNSET HOUR ANGLES OF SLOPE SURFACES WITH SLOPE AZIMUTH AND SLOPE GRADIENT
坡面日出日没时角的配置关系与坡向坡度
12.
Add metal from the rod by dipping the end into the pool so that it melts and makes up the vee.
将焊条一端浸入池内熔化，填满V形坡口。
13.
A study of the improvement of the butt weld groove of a boiler set box and pipe
锅炉集箱和管道对接焊坡口的改进研究
14.
Visual detection of welding groove gap with linear laser source
采用激光线光源的焊接坡口间隙视觉检测
15.
Research on real-time processing images of non-groove butt weld based on structured light
基于结构光无坡口对接焊缝图像实时处理研究
16.
Investigation on the T_(8/5) of Multi-pass Compound Groove Welding for X80 Pipeline Steel
X80管线钢复合型坡口多道焊的T_(8/5)研究
17.
One side welding thermal cycle measuring experiment of heavy plate with V-shape groove
特厚钢板V型坡口单面焊接热循环测定实验
18.
Calculation of layered welding material dosage based on model of variant parameter groove
基于变参数坡口模型分层焊材消耗计算