1.
Analysis on Abnormal Vibration of Luzhou Tuojiang Longxi Bridge s 100m Side Span;
泸州沱江龙西大桥100m边跨振动异常的分析研究
2.
Studies on Mechanism of Vibration Abnormity of Drum Mixer System and Structure Optimization
圆筒混合机系统振动异常机理研究及结构优化
3.
The Mechanical Fault Detection System for Rail Vehicles
轨道车辆走行部振动异常预警系统的技术方案研究
4.
Study on Real-Time Identification of Abnormal Vibration Source of High Buildings
高楼异常振动振源的实时识别技术研究
5.
Dynamic Test and Analysis for Abnomal Vibration on the Frame Structure of Coal Preparation Plant;
选煤厂框架结构异常振动测试与分析
6.
Abnormal Vibration Diagnosis Cause of Coming off of Generator Center Bore Plug
发电机中心孔堵头脱落引起异常振动的诊断
7.
Research on the Abnormal Vibration and Fault Monitoring for Heavy Thin-Slab Hot Rolling Mill;
大型薄板坯热连轧机异常振动与故障监测研究
8.
Using Vibration Signal to Diagnose Abnormal State of Engine Valves Clearance;
基于振动分析的气门间隙异常故障诊断
9.
Diagnosing to Abnormal Horizontal Vibration of the Large-scale Diesel Engine: Theory and Practice;
大型柴油机横向异常振动诊断的理论与实践
10.
Analysis and Processing of the Shafting Abnormal Vibration on the Capacity Extension Unit;
增容改造机组轴系异常振动的分析与处理
11.
Research on Marine Diesel Abnormal Vibration and Methods of Obviating
船舶柴油机异常振动原因分析及排除方法研究
12.
The research of abnormal vibrancy phenomenon about the circulating water pump in the complete sealed plant
全密度装置循环水泵的异常振动现象研究
13.
Analysis and Treatment for Vibration Fault of Low-pressure Rotor for 300 MW Steam Turbine
300 MW汽轮机低压转子异常振动分析及处理
14.
Research on Treatment of the Pay-off Reel's Abnormal Vibration and Control of Its Equipment
开卷机异常振动处理及设备状态把握方法研究
15.
Test and Improvement of Abnormal Vibration of Truck Frame
载货车车架异常振动的试验分析与改进
16.
Solution for Abnormal One-order Critical Vibration of Turbine-generator Set by Low-speed Dynamic Balancing
采用低速动平衡解决汽轮发电机的一阶临界异常振动
17.
MRI is helpful in identifying the interruption of pulmonary artery, the collateral circulation, and the associated cardiovascular anomalies.
磁振造影则相当有助于诊断肺动脉中断、枝循环、及相关心血管异常。
18.
In case of abnormal noise or excessive vibrancy during the running, it is necessary to stop the machine immediately to check and remove the faults.
运转过程中，如发现异常噪声或过大振动应立即停机检查，排除故障。