说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 句库 -> 房间负荷
1.
Study on the Influence of Long Wave Radiation on Space Load
室内长波辐射换热模型对房间负荷影响的研究
2.
Research on the Regularity of Loads and Ventilation Efficiency in Displacement Ventilation Room Using the Two-cell Model;
基于双室模型的置换通风房间负荷及通风效率的规律性研究
3.
Studying of Load Calculation Methods and Its Effecting Aspects in a Displacement Ventilation Space;
置换通风房间负荷计算方法及其影响因素的研究
4.
Influence of Roof's Night Radiation on Cooling Load of Top-floor Rooms
屋面夜间辐射对顶层房间冷负荷的影响
5.
Influence of night radiation on heating load of top-floor rooms
屋顶夜间辐射对顶层房间热负荷的影响
6.
Heating load calculation and energy consumption analysis for gas-infrared heated rooms
燃气辐射供暖房间的供暖负荷计算及能耗分析
7.
Comparison of Two Methods for Hourly Room Air-conditioning Cooling Load Calculation
房间空调逐时冷负荷两种计算方法的比较
8.
The Load Prediction and the Room s Decoupling Control for Ice Stroage Air Conditioning System;
冰蓄冷空调系统的负荷预测和末端房间解耦控制
9.
Study on Variable Load Ratio Characteristic of Multi-connected Air-condition System and the Indoor Fluid Field in Heating Mode
变频多联空调系统供热变负荷特性及房间流场的研究
10.
A load weight is required. The weight must be from %1 to %2. Enter a valid weight.
需要负荷量。此负荷量必须在%1到%2之间。请输入一个有效负荷量。
11.
A load weight is required. The weight must be from %1 to %2. Enter a valid weight.\0
需要负荷量。此负荷量必须在%1到%2之间。请输入一个有效负荷量。\0
12.
Load Factor The load factor is the ratio of the average load to the generator set power rating.
负荷系数负荷系数指的是机组的平均负荷与额定功率之间的比率。
13.
Load Regularity Analysis on Spatial Load Forecasting of Urban Power System
城网空间电力负荷预测中的负荷规律性分析
14.
Research on Short-Term Load Forecasting Model and Method Based on Chaotic Characteristic of Electric Load Time Series;
基于电力负荷时间序列混沌特性的短期负荷预测方法研究
15.
was acclimatized by long hours to overwork;
由于长时间的磨炼而适应超负荷劳动;
16.
A distinction between positive and negative electric charges.
一种正负电荷之间的区别。
17.
ARMAX Model of Ice-storage Air Conditioning System Load Based on Temperature Interval
基于温度区间的蓄冰空调负荷ARMAX模型
18.
Continuous Load A continuous load is a load where the maximum current is expected to continue for three hours or more (as defined by the NEC for design calculations).
持续负荷持续负荷是指使电流在3个小时或更长时间(根据NEC的定义)内需保持最大值的负荷。