1.
A River Closure Research of the First Stage Chaozhou Water Supply Pivot Project Characterized by Weak Foundation;
潮州供水枢纽工程一期软基河床截流研究
2.
Technology Application of River Closure in Chaozhou Water Supply Project
浅谈潮州供水枢纽工程深厚软基河床截流应用技术
3.
Experimental Research on Deformation of Alluvial Flat Soft Ground along Yiluo River;
伊洛河河滩相软土地基变形试验研究
4.
The workers had to go far below the soft bottom of the river. They had to reach rock and remove some of it in order to make a good base for towers.
工人们必须深入软河床下面，必须接触到地底的岩石并挖开它们，以便为塔构筑坚实的基底。
5.
Integrating software -based design of punch bed with welded trunk frame
基于软件集成的箱形焊接结构冲床床身设计
6.
Design and Trial-manufacture of the Bedding Fabrics Based on the CAD Software
基于CAD软件床品织物的设计与试制
7.
Predicting Model of River Bed Form Based on Probabilistic Neural Network
基于概率神经网络的河床床面形态预测模型
8.
A System of Fluvial Process Analysis Based on GIS
基于GIS的河床演变分析系统设计研究
9.
The Research of Soft Subgrade Treatment Technique on Hanio-Hai Phong Expressway
河内—海防高速公路软土地基的处治技术研究
10.
Soft Base Treatment Scheme of Huolin River East Area Urban Road Project
霍林河东区城市道路工程软基处理方案
11.
Nanjing city river west soft soil bottom pit engineering design and construction important point
南京河西软土区基坑工程设计与施工要点
12.
People began to say that a bridge was necessary. The river was very deep and its bottom was soft, so the bridge would have to be very high. Ships had to be able to pass under it.
人们开始谈论需要一座桥。河很深，河床很软，桥必须建得很高，船只必须能从桥下穿过。
13.
Study on Dynamic Softening Standard of Soft Soil under Breakwater with Rubble Mound Foundation
基床式基础防波堤的动力软化判别标准的研究
14.
Study on Anatomical Basis and Clinical Application of Auricular Cartilage for Repairing of Nasal Alar Cartilage Defect
耳廓软骨修复鼻翼软骨缺损的解剖学基础及临床应用研究
15.
On the basis of the hydrologic data from 1981 to 2001, the evolution of river bed at Lanzhou section of the Yellow River was analyzed.
基于1981-2001年水文数据,分析了黄河兰州段河床演变规律;
16.
Research of Movable-bed Resistance and Hydraulic Geometry in Alluvial Channels Based on Extreme Hypotheses;
基于极值假说的冲积河流动床阻力与河相关系研究
17.
MICROCOMPUTER-BASED NUMERICAL CONTROL SYSTEM FOR PUNCH PRESS
基于单片机的冲床专用数控系统的软件设计
18.
The Research of Half-Dry Concrete Rammed Cast-In Situ Pile Build with Weak Roadbed;
半干硬性砼夯扩桩加固铁路软弱基床技术研究