1.
The prediction and control on the springback of the front inner panel of automobile at multi-steps stamping
汽车前车门内板多步冲压成形回弹预测及控制
2.
Remove the trim panel from the front door.
从前车门上拆卸饰板。
3.
Position the front door lower weatherstrip on the door inner panel aligning tape to bottom edge and press into place.
将前车门下部防水饰条移至车门内侧饰板上并将其与下边对齐，按压到位。
4.
Front Door Flag Trim Panel Remove/Install
前车门标记装饰板的拆卸/安装
5.
Analysis and optimization of drawing process for interior car door panel
汽车门内板拉深成形工艺分析与优化
6.
Research and development on 5754 aluminum alloy plate used on the door of sedan
轿车门内用5754铝合金板材的研发
7.
Simulation Study on Forming Process for Automobile Inner Door Panel
轿车车门内板的成形工艺数值模拟研究
8.
Remove the door trim panel as described in Door Module (front door) or Power Window Switch (rear door) in this group.
按本单元的“车门模组”（前车门）或“电动窗开关”（后车门）中所描述的方法拆除车门饰板。
9.
Front Door Inner/Outer Belt Weatherstrip
前车门内侧/外侧防水饰条
10.
Disconnect the power mirror wire harness retainers from the inner door panel.
从内侧车门饰板断开电动视镜电线束扣件。
11.
Remove push-in fastener attaching trim cover to door inner panel (use special tool C-4829).
拆下把装饰盖板固定在车门内板的压入式钩扣（用特殊工具C-4829）。
12.
Remove the right front fender inner splash shielRefer to Group 23 Body for the procedures.
拆卸右前挡泥板的内挡泥板。至于拆卸步骤请参考单元23-车体。
13.
take one's foot off the throttle
脚离开（汽车的）油门踏板.
14.
Remove the door module from the trim panel.
从饰板上拆卸车门模组。
15.
Take one's foot off the throttle, ie off the accelerator, in a car
脚离开（汽车的）油门踏板
16.
Injection Mould Design and Flow Analysis of Front Door Plank of Automobile Based on CAD/CAE Technology
基于CAD/CAE技术的汽车前门板骨架注塑模设计及模流分析
17.
Nathan panicked, tearing at the driver's door, but it wouldn't budge.
内森心急如焚，使劲地拽左前车门，而门却纹丝不动。
18.
"The interior lights include instrument panel lights, various warning, indicator, and courtesy lights which turn on when a car door is opened."
车内灯又包括仪表板灯、各种警告灯、指示灯和车门打开时自动开启的门控灯。