1.
Analyze on Failure Mode of All Composite Cylinder for the On-board Storage of Natural Gas as a Fuel for Automotive Vehicle
车用CNG全复合材料气瓶的失效模式分析及预防
2.
Research on Safety Technique of All Composite Cylinders for the On-board Storage of Compressed Natural Gas as a Fuel for Automotive Vehicles;
塑料内胆复合材料全缠绕CNG气瓶安全技术研究
3.
A Study on Mechanical Behavior of Composite Material CNG Cylinder;
复合材料CNG气瓶的力学性能研究
4.
Numerical Analysis of the Carbon-Fibre Winding Pressure Vessel Using Finite Element Method;
碳纤维缠绕复合材料气瓶的有限元数值分析
5.
Real-Time X-Ray Imaging Technology for Carbon Fiber Composite Cylinders
碳纤维复合材料气瓶的X射线实时成像技术
6.
Structural design and weaving of preformed fabric for manufacturing composite high-pressure cylinder for gases
复合材料高压气瓶用预成型织物的设计与织造
7.
2 High pressure gas cylinders are made of steel, aluminium alloys or composite materials. Cylinder valves need be permanently protected with a removable or permanent (open) cap.
高压气瓶是由钢制，铝合金，或复合材料制成的，瓶阀必须用活动的或不活动的防护帽保护。
8.
The Optimization of the Autofrettage Pressure and the Fiber Thickness of the Fully-wrapped Composite Gas Cylinder;
全缠绕复合气瓶预紧压力和缠绕层厚度的优化
9.
Finite Element Analysis and Optimization Design of the Full-wrapped Composite Cylinders;
全缠绕复合气瓶有限元分析和优化设计
10.
Preparation of SiCp/SiC Composite by Chemical Vapor Infiltration;
化学气相渗透法制备SiCp/SiC复合材料
11.
Study on gas sensitivity property of PANI/PMMA composites
PANI/PMMA复合材料气敏性能研究
12.
Transmission Shaft Reinforced by 3-D Braid with Bladder/VARTM
气囊/VARTM工艺成型三维复合材料传动轴
13.
Microstructure and Properties of In-situ Mg_2Si Particle Reinforced Al Matrix Gradient Composites Cylinder Liner Fabricated by Centrifugal Casting
Mg_2Si颗粒增强自生铝基复合材料气缸套
14.
Progress of Silica Aerogel Insulation Composites
氧化硅气凝胶隔热复合材料研究进展
15.
Argon gas atmosphere furnace brazing of SiC_p/101Al composites
SiC_p/101Al复合材料的氩气保护炉中钎焊
16.
Research development of organic-inorganic gas sensitive nanocomposite
有机-无机纳米复合气敏材料研究进展
17.
Gas Sensitive Materials and Gas Sensors Based on Polymer Nanocomposites;
高分子纳米复合气敏材料及气体传感器
18.
Design and Analysis of Placement Layers for Composite Laminates and Aircraft Inlet
复合材料层合板及飞机进气道铺层设计与分析