说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 句库 -> 孔压变化
1.
Study on Changes in Pore-water Pressure of Clays Based on Self-boring Pressuremeter Test
基于自钻式旁压试验的黏性土孔压变化研究
2.
Pore Water Pressure of Slope Change Rule Research under Dynamic Load;
动力荷载作用下边坡内孔压变化规律研究
3.
A Study on Pore Water Pressure and Time Effect of Pile Bearing Capacity Caused by Penetration of Prestressed Concrete Pile;
管桩静压过程中地基孔压变化及桩承载力时效研究
4.
Measuring analysis on pore pressure of saturated soft clay ground in the sinking of pipe piles
管桩沉桩过程中饱和软粘土地基孔压变化实测分析
5.
Analysis of changes of pressure before the orifices in laterals under low pressure drip irrigation
低压滴灌小孔出流孔前压力变化研究
6.
THE CT TEST FOR POROUS STRUCTURAL CHANGE UNDER COMPRESSIVE LOAD
压缩载荷下孔隙结构变化的CT实验研究
7.
EXPERIMENTAL STUDY ON TIME-DEPENDENT PROPERTIES AND PORE WATER PRESSURE OF SOFT SOIL UNDER UNLOADING
软土卸荷时效性及其孔隙水压力变化试验研究
8.
The system pressure changed the adsorption abilities and pore size distributions of carbide and activated carbon.
反应压力能够改变炭化产物和活化产物的吸附性能和孔径分布。
9.
STUDY ON PORE WATER PRESSRE VARIATION OF DIFFERENT DENSITY LIQUEFIABLE SAND SOIL REINFORCED BY GRAVEL PILE
碎石桩加固不同密实度液化土的孔隙水压力变化规律探讨
10.
The Change Law of Gas Pressure in the Circulation Cavity and Ventilating Quantity of Vent Under Swirl Condition;
旋流条件下通气孔通风量和环流空腔内气体压强的变化规律
11.
Microstructure Changes and Mechanism of Al alloy Pressureless Infiltration into Porous SiC Perform
Al合金无压熔渗多孔SiC预成形坯体的组织变化及机理
12.
Change Rule of Initial Speed of Gas Emission From Borehole in Outburst Coal Seam Before and After Pressure Relief
突出煤层卸压前后钻孔瓦斯涌出初速度的变化规律
13.
Deformation of Porous Pad of an Aerostatic Porous Thrust Bearing
空气静压多孔质止推轴承多孔质圆板的变形
14.
STUDY ON ROCKMASS DETERIORATION AND CHANGES OF POROSITY AND PERMEABILITY IN DOUBLE-POROSITY MEDIUM UNDER HYDRAULIC FRACTURE BASED ON DAMAGE THEORY
基于损伤理论双重介质水力压裂岩体劣化与孔渗特性变化理论研究
15.
In this paper, four calibration methods for pressure leak are introduced, namely, the constant varying pressure, the constant varying volume, the dynamic comparison method with quantitative gas and the dynamic comparison method with a reference leak.
介绍了定容变压法、压变容法、量气体动态比较法、考漏孔动态比较法对正压漏孔进行校准方法。
16.
Optimal Design of Compressor Blade Profile and Aspirated Hole;
压气机叶片型面及吹吸气孔优化设计
17.
Large-deformation Analysis for Cavity Expansion in Strain-softening Soil
应变软化土体扩孔问题的大变形解析
18.
Deformation behaviors and constructive relation of lotus-type porous copper under compressive direction perpendicular to pores
藕状多孔铜沿垂直于气孔方向的压缩变形行为与本构关系