1.
The distribution curve of workpiece temperature induced by the shear heat source is obtained.
得出剪切热源引起的工件温度分布曲线。
2.
Research on Soft Sensor Model for the Inner Temperature of Work in Furnace;
基于软测量的炉内加热工件温度场分布研究
3.
Complementary Detection about Workpiece Temperature of Reheating Furnace Based on BP Neural Network
基于BP神经网络的炉内工件温度互补检测
4.
Environmental conditions appearing in nature of electric and electronic products--Temperature and humidity
GB/T4797.1-1984电工电子产品自然环境条件温度和湿度
5.
Research on Heat Pipe Working Temperature in Electric Furnace Gas Heat Recovery
电炉烟气余热回收中热管元件工作温度的研究
6.
Temperature Distribution of Asymmetrical Heated I-beam Steel
非对称受热条件下工字钢温度分布规律分析
7.
Analytic Expression of Temperature Field of Cylindrical Fuel Element in Dynamic
动态工况下棒状燃料元件温度场的解析式
8.
Zone-area calculation method of temperature distribution of I-shaped steel members exposed to fire on three sides
三面受火条件下工字钢截面的温度场分区计算
9.
INVESTIGATION ON TECHNOLOGICAL CONDITION OF LOWERING FIRING TEMPERATURE OF QINZHOU NIXING POTTERY
降低钦州坭兴陶烧成温度的工艺条件研究
10.
The change of the sensitivity is not influenced by the operation temperature as it is nol very high.
在工作温度不太高的条件下,灵敏度随钯栅厚度的变化基本上不受温度的影响。
11.
Some processing condition such as consumption of monomer, initiator, meutralization degree and polymerizing temperature were explored.
对单体用量、发剂用量、和度、应温度等工艺条件进行了优化研究。
12.
Also may let you act according to the different craft, joins the different chemicals in the specific temperature and under the temperature condition.
也可以让您根据不同的工艺，在特定温度及温度条件下加入不同的药料。
13.
Process window analysis, another part of mold flow analysis, examines melt temperature, mold temperature, injection pressure, and fill times.
加工窗口分析、它零件的模流分析，检查熔体温度、具温度、塑压力和充填时间。
14.
maximum assessed fuel element temperature
燃料元件最高设定温度
15.
The temperature and pressure condition each other.
温度和压力互为条件。
16.
Environmental conditions appearing in nature for electric and electronic products-Solar radiation and temperature
GB/T4797.4-1989电工电子产品自然环境条件太阳辐射与温度
17.
The Simulation of Temperature for Continuously Casting Slabs during Hot Steel Rolling and Designed of the Industry Software;
连铸方坯热送直轧温度场的计算机仿真及工业软件开发
18.
Technology and Numerical Simulation of Temperature and Microstructure of the Flash Butt Welding for Axisymmetric 45 Steel;
45钢轴对称件闪光对焊焊接工艺和接头温度场与组织模拟