1.
Simulation and Driving Torque Experimental Research of the Electronically Controlled Cylinder Lubricator
电控气缸注油器仿真与驱动扭矩试验研究
2.
The Design and Study of Electronic Control System of Cylinder Lubricator for Marine Two-stroke Engine;
船用二冲程柴油机电控气缸注油器控制系统的设计与研究
3.
Numerical Control Optimum Design in Making Automobile Four-Cylinder-Intake-Pipe;
四缸电喷气管模具数控程序优化设计
4.
The Excited Waveform Analysis of the Electrohydraulic Vibrator Based on 2D Valve;
2D阀控缸电液激振器激振波形研究
5.
Manufacture on Electrical Control System for the Electro-Hydraulic Proportional Test-Bed of Absorber;
电液比例油压减振器试验台电气控制系统研制
6.
Air regulator, with two cups, reduce the rust for the cylinder and lubricate the cylinder.
油雾器，采用双杯油雾器，即可减少水对气缸的锈蚀又能起到润滑气缸的作用。
7.
Noise Distribution of Single Cylinder Diesel Engine and Exhaust Noise Control;
单缸柴油机噪声源识别及排气噪声控制
8.
Testing and Simulation on Performance of a New Type of Single-Cylinder Diesel Engine Exhaust Muffler
单缸柴油机新型排气消声器试验与仿真研究
9.
Easy design method for electric circuitry of sequential operating with several cylinders
多气缸顺序动作电气控制回路的简便设计方法
10.
Research and Development of ECU on Two-Stroke GDI Gasoline Engine;
二冲程缸内直喷汽油机电控单元的研究与开发
11.
Direct control of electro-hydraulic stepping cylinder by the use of PLC
电液步进液压缸的可编程控制器直接控制
12.
The carburetor delivers a rich mixture to the precombustion chamber and a lean mixture to the main cylinder.
化油器将浓混合气输至副燃烧室，将稀混合气输送至主气缸。
13.
Performance Simulation Analysis and Improvement of Exhaust Muffler of LJ276M EFI Gasoline Engine
LJ276M电控汽油机排气消声器性能模拟分析与改进
14.
CLOSED LOOP CONTROL OF SPARK ADVANCE USING A CYLINDER PRESSURE SENSOR
使用气缸压力传感器的点火正时闭环控制系统
15.
A Research on MRF-damper-based Pneumatic Positioning Control of Linear Actuator;
基于磁流变阻尼器的直线气缸位置控制研究
16.
Special drastic replacement rings will control compression and oil in cylinders with some taper and out-of-round wear.
在这种情况下,特别精选的油环有助于控制气缸的压力和油耗。
17.
mounded liquefied petroleum gas bullet tank
堆土式子弹形石油气缸
18.
Quality Optimization of Cylinder Bore Surfaces for TJ376Q Gasoline Engines;
TJ376Q汽油机气缸体缸孔加工质量优化