1.
Theoretic and Experimental Research on Three-Roll Cross Wedge Rolling of Non-Quenched and Tempered Steel Hollow Shafts
非调质钢空心轴三辊楔横轧理论与试验研究
2.
Research on Microstructure of Hollow Part During Hot Deformation by 3-roll Cross Wedge Rolling
三辊楔横轧空心件热变形时微观组织的研究
3.
Experiment Research on Compacting Mechanism of Hollow Part with Equal Inner Diameter by 3-roll Cross Wedge Rolling
三辊楔横轧等内径空心件成形机理的实验研究
4.
Numerical Simulation on Compacting Mechanism of Shaft by Trio Cross Wedge Rolling and Experimental Study;
三辊楔横轧轴类件成形机理数值模拟及实验研究
5.
Study on the Evolution of Microstructure of Non-Quenched and Tempered Steel Shafts in the Course of Cooling after Three Rool Cross-Wedge Rooling
非调质钢空心轴三辊楔横轧热成形后冷却相变研究
6.
Finite Element Analysis of Non-Quenched and Temperde Steel Hollow Workpieces by Three-Rolls Wedge Rolling Process of Forming
非调质钢空心件三辊楔横轧成形过程有限元研究
7.
Study on the influence law of the rolling curve affected by rolling radius during cam shaft cross wedge rolling
楔横轧凸轮轴轧制半径对辊形曲线影响的规律
8.
Study on the quality effect of rolled piece internal part in two rolls cross wedge rolling by J.T.S method
J.T.S法对改善二辊楔横轧轧件心部质量的研究
9.
Analysis of Factors Affecting Instantaneous Speed Ratio between Workpiece and Roller of CWR
楔横轧轴类零件轧件与轧辊瞬时速比影响因素分析
10.
The system for 3D-moding of cross wedge rolling die based on STL
基于STL的楔横轧模具三维建模系统
11.
Forming principle of heavy section shrinkage cross wedge rolling by single wedge
楔横轧一次楔大断面收缩率成形机理
12.
vertical roll entablature
(板坯初轧机的)立辊横梁
13.
Numerical Simulation of the 3-D Deformation and Interior Defects Avoidance in Cross-Wedge Rolling Process;
楔横轧三维变形的数值模拟研究及内部缺陷预防
14.
Three-dimensional Rigid-plastic Finite Element Simulation for the Process of Cross Wedge Rolling of Hollow Shaft Parts
空心轴类件的楔横轧过程三维刚塑性有限元模拟研究
15.
Analysis of factors affecting rolling force in rolling zone of eccentric shafts with cross wedge rolling
偏心轴楔横轧轧制区轧制力影响因素分析
16.
Technological Experimental Research for Cross Wedge Rolling Technology of Pin Valve of Oil Pump
油泵油嘴针阀体楔横轧工艺试验研究
17.
Simulation and analysis of camshaft’s precise forming by flat-type cross wedge rolling
凸轮轴板式楔横轧精确成形过程仿真
18.
Simulation and Experimental Study on Rolling Worm Shaft in Cross Wedge Rolling and Cross Rolling
楔横轧与横轧组合轧制蜗杆轴的数值模拟与实验研究