1.
Modeling and Simulation of Tilting Principal Axis Five-axis High-speed Milling Machine
主轴可转位五轴高速铣床的建模与动态仿真
2.
cam shaft displacement control for reversing engines
可倒转发动机的凸轮轴位移控制器
3.
On Spindle Motion Error Separation Based on Virtual-position Reading
基于虚位数据法的主轴径向回转误差分离研究
4.
H~∞ robust control for principal axis speed of variable vector propeller of submersible vehicle
潜器全方位推进器主轴转速H~∞鲁棒控制
5.
Design a robust H_∞ controller for principal axis speed of variable vector propeller
潜器全方位推进器主轴转速鲁棒H_∞控制器设计
6.
"because an eccentric can be attached anywhere along a shaft, it is unnecessary to form any part of the shaft into a crank."
由于偏心轮可装于轴的任何部位,不必把主轴作成曲柄。
7.
They permit the friction disk to slide Back and forth along the shaft But force the disk and the shaft to rotate together.
可以使摩擦盘沿着主轴向后或向前滑动,又可使圆盘和主轴同时转动。
8.
vertical 4 position electric turret
轴式四工位电动转塔
9.
angle of twist per unit length of shaft
轴的单位长度扭转角
10.
Manual and automatic facilities to adjust the phase or relative position between Master and Slave.
可手动自动调节控制器主、从轴的相位或相对位置。
11.
Objects can be repositioned, resized, and reshaped in three axes. They can also be rotated in three axes.
可以在3条轴上调整对象的位置、大小和形状，也可以在这3条轴上旋转。
12.
d range of spindle speeds
主轴转速级数和范围
13.
capstan tachogenerator signal
主导轴转速传感信号
14.
Research on Rotor Position Self-sensing and Power Amplifiers of Active Magnetic Bearings;
主动磁力轴承转子位置自检测及功率放大器的研究
15.
The Calculation of the Angle and Position of the Kingpin Axis Based on Steering Geometric Test
基于转向几何试验的主销轴线角度和位置的解算
16.
Beyond this, the camera viewpoint can be rotated in place or revolved around a focal point, also in three axes.
此外，摄像机视点可以在适当位置旋转，或者围绕某个焦点旋转，也可以在3条轴上旋转。
17.
Research on the reliability of the anterior femoral axis as reference axis to guide the femoral rotational alignment in total knee anthroplasty(TKA)
股骨前轴作为全膝置换股骨假体旋转对位标志的可靠性研究
18.
The reliabililty of trochlear line as referece axis to guide the femoral rotational alignment in TKA
股骨滑车轴作为全膝置换股骨假体旋转对位标志的可靠性研究