1.
Experimental Research on Static and Dynamic Responses of Bridge Longitudinal Truss with Typical Welded Details;
含局部焊接细节的桥梁钢桁架结构静动力响应实验研究
2.
Local dry automatic underwater welding of 304 stainless steel
304不锈钢局部干法自动水下焊接
3.
Study on the Local Criterion of Fatigue Performance in Aluminum Alloy Welded Joints;
铝合金焊接接头疲劳行为局部准则研究
4.
The Study on Local Deformation and Fracture Behaviors for Aluminum Alloy Welded Joints;
铝合金焊接接头局部变形及断裂行为的研究
5.
Assessment of the Local Mechanical Properties and the Damage Study for the Aluminium Alloy Welded Joints;
铝合金焊接接头局部力学性能测试与损伤研究
6.
Part Heat Treatment of Stainless Steel Pipeline Welding Joints in Russia
俄罗斯不锈钢管道焊接接头的局部热处理
7.
Investigation on the local mechanical properties of the automobile aluminium alloy welded joint
轿车用铝合金焊接接头局部力学性能分析
8.
The Research of Welding Materials and Procedures of Partial Repair Supported by Cr3 Back-up Rollers;
Cr3支撑辊局部修复焊接材料和工艺的研究
9.
The Distribution Characteristics of the Local Mechanical Properties with the Aluminium Alloy Welded Joints and the Properties Study of T-type Tubular Joints;
铝合金焊接接头局部力学性能分布特征及T型管接头性能研究
10.
Influence of local heating-cooling on welding residual stress of francis turbine runner
局部加热冷却法对水轮机转轮焊接残余应力场的影响
11.
Influence of local peening on welding residual stress of francis turbine runner
局部锤击法对水轮机转轮焊接残余应力场的影响
12.
The union of two metal parts by welding.
焊接把两个金属部件焊接为一个整体
13.
Application of the twin-wire welding for robot central slot welding
机器人双丝焊在中部槽焊接上的应用
14.
Some regulation is obtained: lack of penetration flaw makes the structure produce the big stress in the part.
焊缝未焊透缺陷仅使结构在局部产生较大应力。
15.
3. Apply flux to outside of tube and inside of solder cup. Surfaces to be joined must be completely covered. Use flux sparingly.
3. 在管道的外面和焊接罩的内部涂上焊剂,焊剂必须完全覆盖焊接表面。请有节制地使用焊剂。
16.
apply flux to outside of tube and inside of solder cup. Surfaces to be joined must be completely covered. Use flux sparingly.
在管道的外面和焊接罩的内部涂上焊剂,焊剂必须完全覆盖焊接表面。请有节制地使用焊剂。
17.
locally-dry semi-automatic underwater welding machine
水下局部排水半自动焊机
18.
Safety requirements for arc welding equipment--Part 1: Welding power sources
GB15579-1995弧焊设备安全要求第1部分:焊接电源