1.
Pole Assignment and Stabilization of Rectangular Descriptor Systems by Dynamic Compensation
基于动态补偿的矩形系统的极点配置与镇定
2.
Study on Gravity Waves Phenomena in Rectangular Fluid-shell Coupled System;
矩形壳液耦合系统中重力波现象研究
3.
Analysis of Low-frequency and Large-amplitude Waves in Rectangular Liquid-elastic Shell Coupled System;
矩形壳液耦合系统低频大幅波的分析
4.
PLC Control System Function Optimizing in Rectangular Slab Water Station
矩形坯水处理PLC控制系统功能优化
5.
Design for the Computer Aided Process Planning System of Rectangle Spline Broach;
矩形花键拉刀计算机辅助工艺系统设计研究
6.
Experimental Study on Deposition Velocity of Particles in Rectangular Ventilation Ducts;
矩形风管系统中颗粒物沉降速度的实验研究
7.
Regularization and Stabilization of Rectangular Descriptor Decentralized Systems;
矩形广义分散控制系统的正则化与镇定
8.
Dynamical Stability of Primary Resonance System of a Thin Rectangular Plate on Nonlinear Foundation in Temperature Field
温度场中矩形地基薄板主共振系统稳定性
9.
Analysis of System Performance Degradation Due to FWM in Square-shaped Pulse DWDM System
DWDM系统矩形脉冲波四波混频影响的分析
10.
Design on Direct Torque Control System of Eighteen-corner Flux
十八边形磁链直接转矩控制系统的设计
11.
Dynamic modeling on flexible rectangular plates system with large overall motion
有大范围运动的柔性矩形板系统动力学建模
12.
AC moving iron rectangular instrument
交流电磁系矩形电表
13.
In facsimile system, a rectangular area, the width of which is the available line and the length of which is determined by the service requirements.
传真系统中的矩形区，其宽度是可用行，其长度由服务要求决定。
14.
The condition of the stability of closed-loop system is finally listed as linear matrix inequation.
闭环系统的稳定性条件最终是以线性矩阵不等式的形式给出的。
15.
Experimental Study on Regularities of Aerosol Particles Deposition in Rectangular Ventilation Ducts;
气溶胶颗粒在矩形风管系统中沉降特性的实验研究
16.
Study on Robust Control for NC Rotary Table Ring Torque Motor Direct Drive Servo System;
数控转台环形力矩电机直接驱动伺服系统的鲁棒控制研究
17.
Study on Fuzzy-Sliding Model Control NC Rotary Table Permanent Magnet Ring Torque Motor Servo System;
数控转台环形力矩电机伺服系统模糊滑模控制的研究
18.
Study on Multi-Objective Robust Control of Permanent Magnet Ring Torque Drive NC Rotary Table Servo System
永磁环形力矩电机驱动转台伺服系统的多目标鲁棒控制研究