1.
Application of thin-layer horizontal well geologic trajectory adjustment technique in well LP 5
薄层水平井地质轨迹调整技术在LP5井的应用
2.
Industry Changes Track and Enterprise Strategy Adjustment: International Perspective;
行业变化轨迹下企业战略调整：国际化视角
3.
A Method of Parameter Range Adjustment in Load Parameter Identification Based on the Trajectory Sensitivity
基于轨迹灵敏度的负荷参数辨识范围调整方法
4.
Symbol for a down lighter. Resize lengthwise or place end to end for different length tracks.
下照灯符号。纵向调整大小或根据不同长度轨迹端对端放置。
5.
The Fuzzy Control Optimized by the Dynamic Parameter Adjustment Genetic Algorithm and Its Application in Robot Trajectory Control;
动态参数调整遗传模糊优化算法及在机器人轨迹控制中的应用
6.
Research on the orbit characteristics for SIGSO satellite and the method to adjust antenna in the earth station
SIGSO卫星运行轨迹特点及地球站天线调整方法研究
7.
Analysis on Profile Track Curve of Grinding Wheel Dressed by Diamond Stylus (Disk-type)
金刚笔(碟片)修整砂轮型面的轨迹分析
8.
The tool-path generation for the integral impeller based on the second development of UG
UG二次开发的整体叶轮刀位轨迹生成
9.
Drag onto the page, then resize lengthwise or place end to end for different length tracks.
拖到绘图页上，然后纵向调整大小，或根据不同长度轨迹采取端对端放置。
10.
Even if a projectile can adjust its flight path, it still must contend with the prospect of enemy electronic jamming.
即使要一发炮弹能够调整其飞行轨迹，还是必须考虑敌方电子干扰的情况。
11.
A Characteritic Loci Design Method Based on Pseudo-Adjustment Algorithm
基于伪调准算法的特征轨迹设计方法
12.
Conveyor width: For equipment with an adjust conveyor width, the front rail is fixed and the rear rail is adjustable. The range of dajustment will vary with the equipment manufacturer.
导轨调整宽度：机器导轨宽度必须可调，前导轨固定后导轨可调，调整范围依制造商而变。
13.
Trajectory Tracking Control of Nonholonomic Mobile Robot;
非完整移动机器人的轨迹跟踪控制问题研究
14.
Point Stabilization and Trajectory Tracking Control on Nonholonomic Mobile Robot;
非完整移动机器人点镇定和轨迹跟踪控制研究
15.
Study of Trajectory Tracking Control Methods on Nonholonomic Mobile Robot;
非完整移动机器人轨迹跟踪控制方法的研究
16.
Study on High-Speed Machining Stability and Tool Path Planning of Integral Impeller
整体叶轮高速加工稳定性与刀具轨迹规划研究
17.
A Toolpath Planning Method for NC Machining of the Hub of an Integrated Impeller
整体叶轮轮毂曲面数控加工刀具轨迹规划方法
18.
AN ANALYSIS OF CRACK GROWTH SIMULATION AND CRACK ARREST IN INTEGRALLY STIFFENED PANEL
整体加筋壁板裂纹扩展轨迹模拟及控制分析