1.
Experiment Study on Reinforced Masonry Walls under out of Plane Eccentric Load;
配筋砌体墙片出平面偏心受压试验研究
2.
Research on the the Behaviors of Structural Column Spacing to Composite Masonry Walls in the Aspect of Eccentrically Compress
关于构造柱间距对组合墙出平面偏心受压性能影响的试验研究
3.
Research on the Effect of upper Structure and Loads for Behaviors of Composite Masonry Walls with Holes Which are Eccentrically Compressed
上层结构与荷载对开洞组合砖墙出平面偏心受压性能的影响研究
4.
The Stability Calculation of Slight Sections Column Pressed by Single-direction Eccentric Force;
窄截面柱单向偏心受压时的稳定计算
5.
Research on Behavior of Inequiaxial Specially Shaped Column Subjected to Biaxial Compression;
不等肢异形截面双向偏心受压柱性能研究
6.
Theoretical Research on the Load Capacity of Eccentric Compressive Circular Section Column by Enclosed Reinforcement;
围套加固偏心受压圆截面柱承载力理论研究
7.
Research on Bearing Capacity of Normal Section for Steel Reinforced Concrete Columns under Biaxial Eccentric Compression
型钢混凝土柱双向偏心受压正截面承载力研究
8.
The limit of dimension eccentric compression under the situation of rectangle asymmetric reinforcement
矩形截面不对称配筋下大小偏心受压的界限
9.
The Test and Theory Study in the In-Plane Stability Capacity of Hot-rolled H-section Columns under Eccentric Load;
热轧H型钢偏心受压构件在弯矩作用平面内极限承载力的理论与试验研究
10.
The Research on the Cross Section s Bearing Ability of Lightweight Aggregate Concrete Eccentric Compressed Cylinder Member;
轻骨料混凝土圆形截面偏心受压构件正截面承载力研究
11.
off-center planeposition indicatio
偏心平面位置显示器
12.
off center plan display
偏中心平面位置显示器
13.
offset-centre plan position indicator
偏心平面位置指示器
14.
off-centered plan position indicator
偏心式平面位置显示器
15.
Experimental study on eccentric compression behaviour of autoclaved flyash-lime brick masonry
蒸压粉煤灰砖砌体偏心受压性能试验
16.
Calculation of the Strength and Checking of the Strength About Large Eccentric Compression Members Made of Reinforced Concrete with Circular Section
钢筋混凝土圆形截面大偏心受压构件的强度计算
17.
Discussion about"Analysis of Correlation Curves between the Axial Force of Eccentrically Pressed Member with Rectangular Cross Section and the Bending Force Moment;
关于“矩形截面偏心受压构件轴力——弯矩相关曲线分析”的探讨
18.
Research on Bearing Capacity of Eccentric Compression Members with Combined Angle Iron Coross-Section
双角钢十字组合截面偏心受压构件承载力试验研究