1.
On-Line Measurement and Control of the Flow in Precise Extrusion of Polymers
聚合物精密挤出过程中挤出流量的在线测量及控制方法
2.
The Flux Analysis of the Plastic Melt in Extrusion Die Circle and Construct Design Channel;
塑料熔体的流量分析与圆环型材挤出模的设计
3.
When you close your hand and press, some of the water gets out.
当你把手握紧挤压时，会流出一些水。
4.
Study on Three-Dimensional Flow of Coat-Hanger Die for Sheet Extrusion
板材挤出衣架式机头三维流场的研究
5.
THE FLOW ANALYSIS OF POLYMER MELT IN CO-EXTRUSION DIE
共挤出机头中的聚合物熔体流动分析
6.
The Stability of Two-Phase Flow Interface in Gas-Assisted Extrusion
气辅挤出成型中两相流界面的稳定性
7.
The Melt Rheological Behavior of m-LLDPE at High Speed Extrusion
m-LLDPE高速挤出流变性能研究
8.
Change rate models of equivalent queue length for congested traffic flow
拥挤交通流当量排队长度变化率模型
9.
At a gestational age of20 weeks and beyond, the pregnant uterus can press against the inferior vena cava and the aorta, impeding venous return and cardiac output.
在怀孕20周以后，妊娠子宫挤压下腔静脉和主动脉，使静脉回流和心输出量受阻。
10.
linear extruder
线性挤压机（用于泡沫染整，液体从缝隙中流出，保持规定的形状、厚薄及数量）
11.
To exude or give off(matter)in drops or small quantities.
使挤出；使滴下以点滴或少量的渗出或排出（物质）
12.
These asisted extrusion technologies had significant effects on improving extrusion rate and product quality, and decreasing energy consumption.
这些辅助挤出技术对提高挤出速率和挤出物质量、低能耗具有重要意义。
13.
Parametric Design and Flow Field Analysis of Pipe Die for Extrusion;
管材挤出机头流道参数化设计及流场分析
14.
Analysis of fluid field in wide sheet extruder die with both end feeding
两端进料式宽幅片材挤出机头流道流场分析
15.
Quantification of the Dynamic Mixing Quality during Twin-Screw Extrusion;
双螺杆挤出过程动态混合质量的量化研究
16.
The amount or rate of emission or ejection.
排放量流量、流速，或排出量，排出的速度
17.
Extruder and hual off adopt AC frequency conversion technology.
挤出机、引机等采用交流变频控制技术，调整方便。
18.
FEM Analysis in the Effect of Die Compression Section on Plastic Extrusion Flow
口模压缩段对塑料挤出流动影响的有限元分析