1.
Remove caliper mounting bolts .
拆卸夹制器固定螺栓。
2.
Install the straps and bolts to hold the propeller shaft to the yoke.
安装扣夹和螺栓，将传动轴固定到轴轭上。
3.
Anchor/support bolt holes are located in base of body.
固定器/支架螺栓孔位于阀门的基座。
4.
Mounting Bolts (Screws)—IAC Motor
固定螺栓（螺丝）—IAC马达。
5.
Mounting and Control on Full Diameter Bolt in 1780 Project in AISC
鞍钢1780工程大直径螺栓固定与控制
6.
Bolts or screws with nuts are widely used for fastening machine and structural components.
带螺母的螺栓或螺钉被广泛用于固定机器以及结构的部件。
7.
The Vanes are hold in place without pin, clamp or bolt, so it is able to be replaced and maintained quickly.
叶片不用销子、夹具和螺栓固定，更容易维修和更换。
8.
Rear Mount To Body Bolts
后固定座与车身螺栓
9.
LEFT ENGINE MOUNT BRACKET LOWER BOLTS
左引擎固定支架下螺栓
10.
The valve cover shall be held in place through the use of a single grooved style two-bolt coupling.
阀盖应该通过单个沟槽状双螺栓联结器固定住。
11.
Sweat Solder adapter with Cover Tube and Cast Set Screw Wall Flange
焊接焊料适配器含盖管和铸造固定螺栓墙法兰
12.
Pre-welding Technology and its Control Method for Bus/Coach Air-Condition Fastening Bolt
客车空调固定螺栓预埋工艺及控制方法
13.
These nuts and bolts hold the wheels on.
这些螺帽和螺栓把轮子固定住了.
14.
Remove hinge retaining nuts from studs.
从双头螺栓拆下固定铰链的螺帽。
15.
These bolts and nuts hold the wheels on.
这些螺栓和螺帽把轮子固定下为。
16.
Install caliper over rotor and into mounting bracket.
在转子上方安装夹制器至固定托架中。
17.
Reinstall handwheel and secure with retaining bolt.
重新安装手轮，用固定螺栓加固。
18.
music holder for fixing to musical instruments
固定于乐器上的乐器夹