1.
Metallic materials--Tube--Flattening test
GB/T246-1997金属管压扁试验方法
2.
Metal tubes-Hydrostatic pressure testing
GB/T241-1990金属管液压试验方法
3.
Rubber hose--Test method for crush resistance
GB/T5566-1985胶管耐压扁试验方法
4.
Figure 3, 4 shows a flat piece of metal that has been through an angle of 180. Sheet metal may be given a single bend test
图3．4表示一片金属扁试样被弯曲180°可以对薄板金属进行单向弯曲试验，
5.
Metallic materials--Compression testing
GB/T7314-1987金属压缩试验方法
6.
Metallic powder-Rattler test for the green compacts
GB/T11105-1989金属粉末压坯的拉托拉试验
7.
Metallic materials--Tube--Ring tensile test
GB/T17104-1997金属管管环拉伸试验方法
8.
Metallic materials--Tube--Flanging test
GB/T245-1997金属管卷边试验方法
9.
testing method for oils of corrosiveness in a bi-metal couple
石油产品双金属管式腐蚀性试验方法
10.
Metallic materials--Tube--Drift expanding test
GB/T242-1997金属管扩口试验方法
11.
Metallic materials--Tube--Bend test
GB/T244-1997金属管弯曲试验方法
12.
Theoretical and Experimental Research on Liquid Metal High Temperature Heat Pipe;
液态金属高温热管的理论和试验研究
13.
Method for flattening test of seamless gas cylinders
GB/T13440-1992无缝气瓶压扁试验方法
14.
Aluminium and aluminium alloys--Compression test method for tubes
GB/T3251-1982铝及铝合金管材压缩试验方法
15.
Plain bearings--Compression testing of metallic bearing materials
GB/T16748-1997滑动轴承金属轴承材料的压缩试验
16.
Method for Testing 220 kV MOA without Removing the HV Lead Conductor
220kV金属氧化物避雷器不拆高压引线的试验方法
17.
During the air pressure test, the test temperature shall be higher than the brittle transition temperature of the metal material.
气体压力的试验时，试验温度必须高于金属材料的脆性转变温度。
18.
bulge test
打压试验, 扩管试验