1.
valve rocker shaft oil pipe adapter
气门摇臂轴油管接头
2.
Hand tighten oil feed line for rocker arm assemblies
用手拧紧摇臂组合的输油管路。
3.
Install the push rods, rocker arms, pivots and bridges in the order they were remove
按照拆卸顺序安装推杆、摇臂、枢轴和桥臂。
4.
Install pitman shaft and side cover in the housing.
在机座中安装转向摇臂轴和侧盖。
5.
Precise 3D Modeling of Design of Arm Shaft;
转向摇臂轴的精确三维造型设计应用
6.
Reason Causing Blowhole in Headstock Housing of Radial Drilling Machine and its Prevention
摇臂钻床主轴箱体气孔产生原因及消除措施
7.
"Essentially, the steering gear consists of two parts, a worm on the end of the steering shaft and a pitmanarm shaft on which there is a gear sector, toothed roller, or stud."
转向器基本上由两部分组成:装在转向轴末端的蜗杆和转向摇臂轴。
8.
Sometimes the camshaft is fitted directly into the cylinder head and operates on the valves without rockers.
有时，凸轮轴直接安装在气缸盖上并且不用摇臂控制阀门工作。
9.
Install the engine cylinder head, push rods, rocker arms, bridges, pivots and engine cylinder head cover.
安装引擎汽缸盖、推杆、摇臂、桥、枢轴和引擎汽缸盖罩。
10.
"With this arrangement, the camshaft is directly below the valve lifter, and no push rods or rocker arms are necessary. "
"在这种装置中,凸轮轴直接装在气门挺杆下,并且不必有推杆或摇臂。"
11.
"The gear sector, toothed roller, or stud meshes with the worm."
转向摇臂轴上装有扇形齿轮、带齿滚柱或指销,用以和蜗杆啮合。
12.
universal raidial milling machine(horizontal)
万能摇臂铣床（卧）
13.
Study on Oil Film-Roller Combination Bearing of φ200 Cantilever Finishing Mill;
φ200悬臂式精轧机油膜—滚子组合轴承开发研究
14.
"There are two general types of power steering. One type is self-contained, with all hydraulic pressure applied to the pitman arm shaft."
动力转向一般具有两种类型。一种是独立的,所有的液压力都施加在摇臂轴上。
15.
Application of Swing Arm Tower Crane Erection Technology in 1000 kV UHV Double Circuit Steel Pipe Tower Construction
摇臂抱杆组塔技术在1000kV特高压双回路钢管塔施工中的应用
16.
Analysis of Influence Factors on Marine Diesel Engine Crankshaft Deflection and Study of Digital Measuring Instrument;
船舶柴油机曲轴臂距差影响因素分析及数字显示测量仪研究
17.
hand-rocking universal woodworking circular saw
摇臂式万能木工圆锯机
18.
hydraulic and electronic swing arm cutting machine
液压电子摇臂式裁切机