1.
Tie Rod End To Steering Knuckle Nut
转向拉杆端与转向关节螺栓
2.
Separating Ball Joint Stud From Steering Knuckle
球形接头螺桩与转向关节分开
3.
Tie Rod End Adjusting Sleeve Nut
转向拉杆端调整轴筒螺栓
4.
steering arm adjusting screw wrench
转向臂调节螺钉扳手
5.
Remove the universal joint strap bolts at the pinion shaft yoke.
在小齿轮轴轴轭处拆卸万向节扣夹螺栓。
6.
Using a wrench, loosen the diaphragm assembly by turning the hex bolt counterclockwise.
用扳手反时针方向旋转六角螺栓，松开隔膜总成。
7.
Research of Recognition Algorithm for Plate Bolt of Train Wagon Bogie
货车转向架心盘螺栓丢失识别算法研究
8.
hinge (guide) bracket bolt
绞链(导向)托架螺栓
9.
High strength bolts for joints of space grid structures
GB/T16939-1997钢网架螺栓球节点用高强度螺栓
10.
Remove the upper flywheel and converter housing bolts and loosen the bottom bolts.
拆卸上部飞轮及转换器外壳螺栓，拧松底部螺栓。
11.
Using a wrench, reassemble the diaphragm assembly by turning the hex bolt clockwise to tighten.
用扳手，顺时针方向旋转六角螺栓重新组装隔膜总成，并将其紧固。
12.
Steering Knuckle Separation From Driveshaft
转向关节与驱动轴分离
13.
Clevis Bracket To Steering Knuckle
U型环支架至转向关节
14.
Remove the steering knuckle from the strut.
自支柱拆除转向关节。
15.
Comparable Analysis of the Statics Characteristic of Dumbbell-Sphericity s Node of Bolt Globe;
哑铃状螺栓球节点与圆球状螺栓球节点静力特性比较分析
16.
The hub and bearing assembly does not require removal from the steering knuckle to replace wheel attaching studs in the hub and bearing assembly.
更换轮毂及轴承组件内的车轮固定螺桩无需自转向关节中取出轮毂及轴承组件。
17.
"Bolts,screws & nuts"
"螺栓,螺丝及螺帽"
18.
Throttle Body Mounting Bolts—Engines—Typical
节气阀体固定螺栓—引擎—典型的