1.
Screw, crank cover
曲柄轴盖子固定螺丝
2.
The metal case enclosing the crankshaft and associated parts in a reciprocating engine.
曲柄轴箱在往复式发动机内将曲柄轴和相关部件包住的金属箱子
3.
The cap and rod have bearings which permit the crankpin to rotate freely within the rod.
轴瓦盖和连杆中有轴瓦，它允许连杆内的曲柄锁自由地转动。
4.
A shaft that turns or is turned by a crank.
机轴用曲柄来转动的轴
5.
The crank is an offset section of the crankshaft.
曲柄是曲轴的偏置部分。
6.
steering clutch release crank axle
转向离合器开关曲柄轴
7.
Turn the wiper module over and remove the nut that secures the wiper motor crank arm to the wiper motor output shaft.
转动雨刷模组盖，并拆下将雨刷马达曲柄臂固定于雨刷马达输出轴上的螺帽。
8.
As the crankshaft rotates, the crankpin swings in a circle around the shaft.
随着曲轴的转动，曲柄销绕主轴作圆周摆动。
9.
Thai type pipe wrench with double-curved handle
泰式双曲柄管子扳钳
10.
The rod-bearing cap attaches the connecting rod to the crankpin.
连杆轴瓦盖将连杆安装到曲轴销上。
11.
A device for transmitting rotary motion, consisting of a handle or arm attached at right angles to a shaft.
曲柄一个传递转动的部件，包括一个手柄或把手与一个轴直角相连
12.
a piece of leather-covered metal with a flexible handle; used for hitting people.
一种有曲柄的有皮革覆盖的金属；用来打人。
13.
Concept of Coaxial Secondary Counterbalanced Beam Pumping Unit and Energy-Saving Analysis
一种同轴二次曲柄平衡抽油机方案及性能分析
14.
"because an eccentric can be attached anywhere along a shaft, it is unnecessary to form any part of the shaft into a crank."
由于偏心轮可装于轴的任何部位,不必把主轴作成曲柄。
15.
The fresh-air inlet was usually the crankcase breather cap.
新鲜空气进口一般是曲轴箱通气盖。
16.
The radius of a circle described by a crank, cam, or similar machine part.
(曲轴的)半径曲柄、凸轮或类似机器部件形成的圆的半径
17.
Numerical Simulation and Experiment Study on Forging Technique of Large Marine Assembled Crank of Crankshaft;
船用大型组合式曲轴曲柄锻造工艺的数值模拟及实验研究
18.
Insert Timing Case Cover Alignment and Seal Installation Tool 6139 in the crankshaft opening in the cover .
在曲轴盖的开口处，插入正时箱盖定位和轴封安装工具6139。