1.
oil-filled enclosure (Ex o)
充油外壳（Ex o）
2.
powder-filled enclosure (Ex q)
充砂外壳(Ex q）
3.
Fill the oil pan with oil to the specified level.
用油填充油底壳到规定油面。
4.
Enclosure Gel filled, ultrasonically welded, high density ABS housing.
附胶体填充，超声焊接，高密度abs外壳。
5.
Multi-station Progressive Die Design on Charger Shell Based on UG
基于UG充电器外壳多工位级进模设计
6.
The vacant place is taken by one of the outer electrons which thus leaps from an outer to an inner "shell".
真空穴由一个从外“壳”跃至内“壳”的外层电子来填充。
7.
sealed housing evaporative emission determinatio
密封外壳燃油蒸发排出物确定
8.
Influence of Temperature on the Gap between Concrete and Steel Liner in Spiral Casing Structure;
温度对充水保压蜗壳结构蜗壳与外围混凝土间隙的影响
9.
Oil on the nutshell surface is toxic and corrosive to human skin, so the nut is dried and roasted to extract the oil and to make the shell brittle.
外壳表面的油有毒，会腐蚀人类皮肤，因此腰果必须经过干燥烘焙，抽出油脂，让外壳变脆。
10.
Lubricate O-ring with power steering fluid and install into the housing.
用动力转向油润滑O型环，并将其安装在外壳上。
11.
Slide and tap in reservoir retainer clips until tab locks to housing.
滑动并敲击贮油槽扣件夹，直至凸耳锁紧外壳。
12.
The Technological Process Analysis of Stamping Forming for the Outside Shell of Fuel Tank of Ride-Motorcycle
骑式摩托车油箱外壳体冲压成形工艺过程分析
13.
Protective coverings for electric cables-Specific protective coverings for oil-filled cables with lead sheath
GB/T2952.4-1989电缆外护层铅套充油电缆特种外护层
14.
The evaluation also proposes supporting the ban of single-shell tankers to prevent crude oil leakage.
评估中也建议支持废除单壳油轮航行的行动，以加强防止原油外泄。
15.
water-tight case
不透水外壳, 耐水外壳
16.
Study of the Rabbit Bone Mesenchymal Stem Cells Cultured in Vitro on Chitosan Scaffolds;
兔骨髓间充质干细胞在壳聚糖支架上培养的体外研究
17.
If the level is below the maximum mark, top up with the right grade of Shell Helix.
如果油量低于最小刻度，则应选择正确级别的壳牌喜力发动机润滑油给予添加补充。
18.
Also ask your garage to check the level and condition of your oil and top up with the appropriate grade of Shell Helix, if required.
同时还应要求维修人员检查机油液面，必要时补充一些适当级别的壳牌喜力润滑油。