1.
Measures for improving the concentricity of the bearing s minor hole at the two ends;
提高套筒两端轴承档内孔同轴度的措施
2.
fan end thrust ball bearing
风扇端止推滚球轴承
3.
SMALLER DIAMETER OF PIVOT BEARING
轮毂轴承的较小直径端
4.
End play in drive pinion bearings.
驱动小齿轮轴承的端隙。
5.
Pressure-compensated air bearings are used on both ends of the trunnion axis.
耳轴两端各用一压力补偿空气轴承。
6.
Spherical plain bearing rod ends-Boundary dimensions and tolerances
GB/T4222-1991杆端关节轴承外形尺寸和公差
7.
Spherical plain bearing rod ends-Boundary dimensions
GB/T9161-1988杆端关节轴承外形尺寸
8.
automatic grinding machine for end face of needle bearing ring
自动滚针轴承套圈端面磨床
9.
Embedded Bearing Fault Diagnosis System DSP Side Design;
嵌入式轴承故障诊断系统的DSP端设计
10.
The trunnion assembly is supported by air bearings at the end of each arm and is held in position by brake shoes at each bearings.
耳轴组件的支承是每根臂末端的空气轴承，轴承上的闸瓦起定位作用。
11.
Permanently sealed and lubricated ball bearings front and rear.
前后端盖装有永久密封和自润滑的滚珠轴承。
12.
Analysis of roller end wear question for high speed short cylindrical roller bearing
高速短圆柱滚子轴承滚子端面磨损问题分析
13.
Analysis of rock-socketed pile uniaxial compressive strength and bearing capacity of pile tip at three dimensional effects
嵌岩桩单轴抗压强度和三维作用下桩端承载力
14.
Shaft Assembly (Male, female, washer, grease….
轴组件（轴，轴套，轴承，油脂。。。）
15.
Bearing Clearance (#1 Journal)
轴承间隙（#1轴颈）
16.
In addition, in order to avoid conducting the heat which results from the clea- rance of bearings to the cold end of the turbine, a special construction of jou- rnal beairngs cooled by water inside is employed.
此外,为了避免轴承间隙内生成的热量传到透平冷端,采用了轴承内腔水冷却的结构。
17.
The bottom bearing applies both labyrinth seal and frame seal, which have good performance of sealing. The main shaft is anticorrosive.
下轴承端盖密封采用双重密封，可确保密封效果，主轴采用防腐新技术，能保护主轴免受腐蚀。
18.
"The four arms of the spider, known as trunnions, are assembled into bearings in the ends of the two shaft yokes."
万向节十字轴的四个轴颈叫做万向节十字头,分别装在两个万向节叉顶端的轴承中。