1.
The Principle of the Bit Recovery of the Modelling Method for Positive/Zero/Negative Justification
模型法正/零/负码速调整的码速恢复原理
2.
Design on a Novel Wireless Positive/Zero/Negative Justification
一种新型无线信道正零负码速调整设计
3.
The governor must have provision for adjusting speed( generator frequency) and speed droop( no load to full load).
调速器必须具备转速调整（电机频率）降速降调整（负荷到满负荷）能。
4.
Design and realization of Positive justification based on FPGA
基于FPGA的正码速调整的设计与实现
5.
The governor must have provision for adjusting speed (generator frequency) and speed droop (no load to full load).
调速器必须具备转速调整（发电机频率）和降速降调整（零负荷到满负荷）功能。
6.
The response rate speed governor to the given power signal directly affects the load regulating process of generatorset.
调速器对功率给定信号响应速度，直接影响著机组负荷的调整过程。
7.
HS Code 3809.10 (finishing agents)
协调制度编码 3809．10 （整理剂）
8.
on load voltage and phase regulator
负载时电压相位调整器
9.
AU Pointer Negative Justification
管理单元负指针调整
10.
SHOCK ABSORBERS (REAR LOAD LEVELING)
避震器（后负荷水平调整）
11.
differential adjusting wrench
分速分速器轴承调整扳手;分速器轴承调整扳手
12.
An International Comparison of Macro - taxation and Adjustment of Taxation in China;
宏观税负的国际比较与我国税负调整
13.
Joint Optimization of Rate Allocation and Decoding Order Adjustment in DS-CDMA Systems with Successive Interference Cancellation
采用串行干扰消除的DS-CDMA系统中速率分配与译码顺序调整的联合优化
14.
A Study of Emulation About Speed -load Character of Speed-control Circuits;
节流调速回路速度负载特性仿真研究
15.
Analysis of the Static Characteristic of Throttle Velocity Regulating Circuits
节流调速回路的速度-负载特性分析
16.
quick spindle adjustment
(钻床) 快速主轴调整
17.
minimum adjustable table speed
工作台最小调整速度
18.
engine idling speed adjusting screw
发动机怠速调整螺丝