1.
Install the battery and connect the battery cable.
安装电池并连接电池电缆。
2.
Connect battery cables positive first.
连接电瓶电缆，先连接正极电缆。
3.
earthing cable bond
电缆铠甲的接地连接器
4.
umbilic(al) connector
临时管道及电缆连接器
5.
Direct cable (a cable that connects your computers' serial ports)
直接电缆(直接连接到计算机的串行口的电缆)
6.
One of two cables used for carrying electric current from one car battery to another one that has no power in it.
跨接电缆（用以从一汽车电池向另一无电的汽车电池输电）。
7.
connect the two poles of battery
把电池的两极连接起来
8.
Directly connected by electrical wires or cables.
由电线或电缆直接连结的
9.
Connect negative (ground) cable to the battery.
将负极（地）电缆连接到电瓶。
10.
Research on Equipotential Bonding of Copper Cable in 500 kV Substation
500 kV变电站等电位连接铜缆方式研究
11.
Do not connect the battery negative cable at this timSee Airbag System in the Diagnosis and Testing section of this group for the proper procedures.
此时切勿连接电池负极电缆。有关相应的程序请参阅本单元的诊断与测试部分。
12.
Disconnect the battery negative cable.
断开电池负极电缆。
13.
Always grasp the connector and do not pull the cable when disconnecting the bus cable or other cables. Otherwise the cable may become detached.
当断开总线电缆或其它电缆时，必须抓住连接器，不要拉电缆。否则，电缆可能断开。
14.
The CLP and HEC transmission systems are interconnected by a cross-harbour link.
中电与港灯的输电系统，由横跨海港的电缆连接。
15.
cable distribution box
电缆交接箱，电缆分线盒，电缆终端盒
16.
Make sure all cable connections are secure.
确保所有电缆连接均能安全工作。
17.
General specification of flat cable connector
GB/T9538-1988带状电缆连接器总规范
18.
a unit for connecting 2 cables without the need for plugs.
连接条电缆而不用塞子的单位。