1.
Development of Thermal?comfortable Fabrics by using ?the Single Plate Weft?knitted Structure
利用纬编单面添纱组织开发热湿舒适性针织面料
2.
Research on the Plating Effect and Properties of Plated Knitting Fabrics of New Filament;
新型纱线添纱织物的添纱效果和性能研究
3.
double-knitted plaited fabric
双面编结添纱针织物
4.
Analysis of yarn feeding angle on small diameter weft knitting plated fabric
小筒径针织纬编添纱织物的垫纱角度分析
5.
Knitted with two kinds of yarn, one on the face and one on the back.
添纱的用两种纱线分别在正反面编织的
6.
The warp yarn goes over, or floats over, two filling yarns and under one in the 2/1 twill.
斜纹组织中,经纱位于(或浮于)两根纬纱之上,然后位于一根纬纱之下。
7.
Study on Knitting Process and Thermal-wet Comfort of Single Weft Knitting Plated Fabric;
单面纬编添纱织物编织工艺及热湿舒适性能研究
8.
fabric of casein filament yarn, woven, containing less than 85% by weight of such yarn (excl. tyre cord fabric and pile and chenille fabrics)
机织酪蛋白纤维长组织上纱织物,含此类纱重量低于85%（不包括绒头和绳绒织物）
9.
mignonette net
机织网眼纱[织物]
10.
The angle of the diagonal is determined by the closeness of the warp ends, the number of yarns used per 10 cm, the diameter of the yarns used, and the actual progression forming the repeat.
影响斜纹线倾角的因素有经纱的紧密程度、纱线的密度、纱线的直径、以及完全组织中实际的飞数。
11.
In weave patterns such as sateens or wrap-faced twills, one set of yarns predominates on the fabric surface.
例如纬缎或经面斜纹组织，其中有一组纱线浮现在织物表面。
12.
Twills differ from plain weave in the number of filling picks and warp ends needed to complete a repeat pattern.
斜纹织物与平纹织物在一个完全组织中所采用的纱线根数不同。
13.
Research on Pretreatment of PLA/Cotton/PTT Three Components Core-spun Yarn Knitted Fabric
玉米/棉/PTT三组分包芯纱针织物前处理工艺研究
14.
Observation on Efficacy of Medicinal Oil Gauze on Acute Closed Soft-Tissue Injury
药物油纱治疗急性闭合性软组织损伤疗效观察
15.
Investigation on Effects of Different Additions on Microstructures and Properties of Cu-W Alloys;
添加相对CuW合金组织与性能的影响
16.
Figure weaves, also identified as fancy weaves, decorative weaves, or complex weaves, are formed by predetermined changes in the interlacing of the warp and filling yarns.
花式组织,又称为装饰组织或复杂组织,是通过预先确定的经纬纱交织规律的变化而形成的。
17.
Among fabrics with the same number of yarns required for the repeat, a fabric with a high fabric count will have shorter floats than one with a low fabric count.
对于某些织物,如果完全组织中的纱线根数相同,则纱线密度较大时其浮长线较短。
18.
Triaxial fabrics are woven by three sets of different direction alignment of yarns, interlacing in an angle of 60 degrees respectively.
平面三向织物是由三组纱线互成60°左右的夹角交织而成。