1.
Remover, Moldings C-4829
拆卸工具，嵌条C-4829
2.
REAR HEADLINER TRIM MOLDING
后车顶蓬内衬装饰嵌条
3.
Apply the molding to the windshield:
将嵌条应用至挡风玻璃：
4.
REAR DOOR GLASS EXTERIOR MOLDING
后车门玻璃外观嵌条
5.
The slot seam is a decorative seam.
嵌条缝是一种装饰缝。
6.
A thin, flat molding used as separation between or ornamentation for larger moldings.
平缘用来隔开或装饰更大嵌条的扁平嵌条
7.
Install beltline molding and weatherstrip seals.
安装装饰带嵌条及防水饰条密封。
8.
The easiest form of inserting is that used for a piped seam.
镶嵌最简单的形式就是采用嵌条缝(夹紧缝)。
9.
Snap molding down over top of retaining clips.
向下压紧嵌条至固定夹上方。
10.
A wide vertical band in the center of an escutcheon.
垂直宽条在一个饰有纹章的盾的中心部分的一条较广的垂直嵌条
11.
Starting at the forward end of the upper molding, force the molding onto the door panel flange and continue rearward until it is completely seated on the flange.
从上部嵌条的前末端开始，用力使嵌条到车门饰板上并且继续向后直到它完全固定在凸缘上。
12.
Install liftgate opening (headliner) upper trim molding.
安装升降闸门开口（车顶蓬内衬）上装饰嵌条。
13.
Remove liftgate opening (headliner) upper trim molding.
拆去升降闸门开口（车顶蓬内衬）上装饰嵌条。
14.
For curved slot seams, both sides of the seam must be faced and underlay follows the same curve.
弧形嵌条缝,缝的两边必须对称,垫层的弧度相等。
15.
A narrow border, molding, or fillet.
扁带饰窄条，装饰用嵌线或窄带
16.
embedded stripe double-heterostructure laser
嵌入式条状双异质结构激光器
17.
A thin, dressed rectangle of stone for facing walls.
整形块石嵌饰墙面的长条形琢石
18.
Research on Embedded Controller for Oblique Cutting Machine Based on ARM;
基于ARM的嵌入式斜条机控制器的研究