1.
Higher order Path-Remote Error Indication
高阶通道远端错误指示
2.
The client could not establish a connection to the remote computer. The most likely causes for this error are:
客户端无法建立到远程计算机的连接。导致这个错误的可能原因是:
3.
teleprocessing error record
远程信息处理错误记录
4.
Command-line error: Invalid port for serial port mapping.
命令行错误: 串行端口映射的端口无效。
5.
Because of a security error, the client could not connect to the remote computer. Verify that you are logged on to the network, and then try connecting again.
由于安全错误，客户端无法连接到远程计算机。请确认您已登录到网络，然后重新连接。
6.
Because of a security error, the client could not connect to the remote computer. Verify that you are logged on to the network, and then try connecting again.\0
由于安全性错误，客户端无法连接到远程计算机。请确认您已登录到网络，然后重试连接。\0
7.
An error occurred when the client attempted to connect to the remote computer. Check your system memory and then try the connection again.
客户端试图连接到远程计算机时出现错误。请检查系统内存，然后尝试重新连接。
8.
A licensing error occurred while the client was attempting to connect (Licensing timed out).Please try connecting to the remote computer again.
客户端试图连接时，出现了一个授权错误(授权超时)。请再尝试连接到远程计算机。
9.
Signifies that an error occurred during processing of a save function involving accessing data from a remote URL.
表示当执行一个需要通过URL访问远端数据的save类别的函数时产生了错误。
10.
Headend Service: Unexpected error. Please try again later.
数据头端服务: 意外错误。请稍后重试。
11.
Command-line error: Invalid parallel port mapping.
命令行错误: 无效的并行端口映射。
12.
Unexpected error occured while configuring ports for testing.
配置要测试的端口时发生意外错误。
13.
Error, Number of ports should be 4,8,16,32,48 or 64.
错误，端口号应该为4、8、16、32、48或64。
14.
The wrong device is attached to the port.
一个错误的设备被连接到该端口。
15.
Number of Terminal Services transport-level errors on input.
输入时终端服务传输层的错误数目。
16.
Number of Terminal Services transport-level errors on output.
输出时终端服务传输层的错误数目。
17.
Client connection has been terminated due to an error condition
由于发生错误，导致客户端连接中断
18.
Client disconnected due to internal protocol error:
由于内部协议错误，客户端已中断连接: