1.
after bottom dead center
下死点后在下止点后
2.
after top center
上死点后在上止点后
3.
before bottom center
下死点前在下止点前
4.
So the exhaust valve opens before BDC and closes after TDC.
因此排气门在下止点之前打开，在上止点之后关闭。
5.
At 2: 25p.m, his heart ceased to beat.
在下午２点２５分他的心脏停止了跳动。
6.
About 24 days later the ovules showed progressive shrinkage accompanied by a cessation of growth of the adventive embryos.
24天后,在无胚乳的条件下,停止生长。
7.
Drag onto the page to add a device for preventing the mechanism from stopping in the dead center position.
拖到绘图页后，可以添加一种防止机械装置在死点位置停止的装置。
8.
Treatment of posterior cruciate ligament avulsion fracture with small incision in posterior surface of knee joint
经膝后下方小切口治疗后交叉韧带胫骨止点撕脱骨折
9.
Being practically naked, there is a certain inhibition and vulnerability.
在完全赤裸后，就有了某种禁止和弱点了。
10.
before top dead center
在上死点前在上止点前
11.
Prevents a page break from leaving a single line of a paragraph on one page
分页时防止段落的最后一行留在下一页中
12.
As the ship went beyond the horizon, it appeared to sink until it could be seen no longer.
船越过地平线后，就似乎在下沉，直到消失为止。
13.
Arthroscopic suture fixation with cannulated screw and washer for bony avulsion of the posterior cruciate ligament
关节镜下治疗后交叉韧带胫骨止点撕脱性骨折近期疗效观察
14.
If the exhaust valve opened at BDC at the beginning of the exhaust stroke and closed at TDC at the end of the exhaust stroke, it would have a duration of 180°.
如果排气门在排气行程的下止点打开并且在这次行程的上止点关闭，它将有180°的持续。
15.
Meeting was adjourned at [time] by [person]. The next general meeting will be at [time] on [date] in [location].
[姓名]在[时间]中止会议。下次会议时间: [日期][时间]，地点: [地点]。
16.
Application Study of Termination Site of Reentrant SVT by USTS during Mapping the Sites of RFCA;
超速阈下串刺激终止折返性SVT的位点在RFCA靶点定位中的应用研究
17.
Puppies should not be allowed to socialize with other dogs or frequent areas where other dogs have been until2 weeks after they have had their last vaccination.
犬类在最后一次免疫接种后2星期内禁止与其他犬类接触，禁止前往其他犬类经常出没的地点。
18.
The Bore is the diameter of the cylinder. The stroke is the distance the piston travels from BDC (Bottom dead center) to TDC(top dead center). The Bore is always mentioned first.
内径指的是气缸的直径;行程是活塞从下止点运行到上止点的距离。表述时,内径总是写在前面。