1.
The results show that the flow field structures on longitudinal section are similar in a certain crank angle range before TDC.
计算结果表明,在上止点前较大的曲轴转角范围内,纵剖面流场结构相似.
2.
equilateral hyperbola
直角双曲线, 等轴双曲线
3.
A shaft that turns or is turned by a crank.
机轴用曲柄来转动的轴
4.
counter crankshaft rotation
反曲轴转动方向的转动
5.
The rotational angle of a ball around its rotational axis.
转轴角-----球旋转时转轴的水平角度。
6.
The camshaft rotates in phase with the crankshaft, but at half its speed.
凸轮轴和曲轴协调旋转, 但速度仅是曲轴的一半。
7.
A device for transmitting rotary motion, consisting of a handle or arm attached at right angles to a shaft.
曲柄一个传递转动的部件，包括一个手柄或把手与一个轴直角相连
8.
steering clutch release crank axle
转向离合器开关曲柄轴
9.
The Research of the Deformation in the Rolling Process for Strengthen Crankshaft;
曲轴圆角滚压强化工艺中曲轴变形的研究
10.
Analysis of Inspection and Measuring Method for 120° Distributing Angle Errors of Crankshaft Crankpins
曲轴曲拐120°角度误差检测方法分析
11.
The crankshaft makes three rotations for each rotation of the rotor.
转子每转一周，曲轴转3周。
12.
As the crankshaft rotates, the crankpin swings in a circle around the shaft.
随着曲轴的转动，曲柄销绕主轴作圆周摆动。
13.
angle of twist per unit length of shaft
轴的单位长度扭转角
14.
The ratio of the crankshaft to the revolutions of the camshaft is 2∶1.
曲轴的转速与凸轮轴的转速之比是2∶1。
15.
This means that the crankshaft will make two revolutions for every revolution of the camshaft.
这意味着凸轮轴每旋转一次曲轴将旋转两次。
16.
Axial load-deformation curve and preload on angular con act ball bearings
角接触球轴承的轴向载荷—变形曲线和预紧
17.
crank angle signal sender
曲柄转角信号发送器
18.
Analysis on Measuring Accuracy in Inspecting Crank Angles for Six-cylinder Crankshafts
六缸发动机曲轴曲拐夹角检测方法的精度分析