1.
"When the crankshaft is removed, it is the usual procedure to clean out the oil passages in the crankshaft."
拆卸曲轴时,通常应该清洁曲轴油道。
2.
A Special Machine Tool for Manufacturing Oblique-Oil-Passages on Diesel-Crankshaft and Its Controler;
柴油机曲轴斜油道加工专用机床及控制
3.
Install new front crankshaft oil seal.
安装新的前曲轴油封。
4.
crankcase oil foaming
曲轴箱润滑油起泡沫
5.
crankcase oil drain cock
曲轴箱放油开关［旋塞］
6.
crankcase oil foaming test
曲轴箱用油起沫试验
7.
Remove and discard the front crankshaft oil seal.
拆下并抛弃曲轴前油封。
8.
The Study on Running-in and Wear Properties of Crankshaft-bearing Shell of Diesel Engine
柴油机曲轴-轴瓦磨合磨损性能研究
9.
The Performance Analysis of Diesel Crankshaft and the Research for Calculation Method of Crankshaft Fatigue Strength;
柴油机曲轴性能分析及曲轴强度计算方法研究
10.
The Test and Alignment Without Flat Board of Bend Axis of The Diesel Engine;
柴油机曲轴弯曲的无平板检测及校直
11.
Analytical Investigation on Strength and Main Bearing Lubrication of CA4D32 Diesel Engine Crankshaft System Based on a Simulation Technique;
柴油机曲轴轴系强度和主轴承润滑仿真研究
12.
Analysis of Alignment of Shaft-core Line Between Crankshaft of Marine Diesel and Thrust Shaft
船舶柴油机曲轴与推力轴轴线校中分析
13.
Study on Load Analysis Method for Diesel Engine Crankshaft Main Bearing Based on ADAMS;
基于ADMAS的柴油机曲轴主轴承载荷分析方法研究
14.
Development of the Recognition System for output Shaft Type of Gasoline Engine Crank;
汽油发动机曲轴输出轴类型识别系统的研制
15.
Multi-body Dynamics Simulation of Crankshaft System on 4DC Diesel Engine;
4DC柴油机曲轴轴系多体动力学仿真研究
16.
Multi-body Dynamics Simulation of Crankshaft System on Marine Diesel Engine
船舶柴油机曲轴轴系多体动力学仿真研究
17.
Study on Lubricating Characteristics of Crankshaft Main Bearing for High-duty Diesel
高强化柴油机曲轴主轴承润滑特性研究
18.
Numerical Study on Nonlinear Dynamic Characteristic of Crankshaft System of Diesel Engine
柴油机曲轴轴系非线性振动特性的数值研究