1.
lowest continuous speed test with load
最低稳定工作转速试验
2.
minimum steady speed operation test for main engine
主机最低稳定工作转速试验
3.
Min steady speed
直接档最低稳定速度(Km/n)
4.
Stable performance and low processing cost.
性能稳定，加工成本低，目前应用最广泛。
5.
Effect of High Speed Spinning of Solid Fuel Ramjet on Steady Operation Range of Its Inlet
固体燃料冲压发动机高速旋转对进气道稳定工作范围的影响
6.
The Village level FP Work and Stabilizing the Low fertility Level;
村级计划生育工作与稳定低生育水平
7.
The minimum payment for a legal working hour of an employee in FFEs must not be lower than the standard for the local minimum payment.
职工法定工作时间内的最低工资，不得低于当地最低工资标准。
8.
Furthermore, for more accurate simulation, a nonlinear 8 DOF vehicle model was used to analyze the step steering response of the rhombic car.
仿真结果表明，菱形车在高、低速时具有快速、稳定的转向响应特性。
9.
Research on flow instability triggering process at stall condition of transonic compressor rotor at low Reynolds number
低雷诺数下跨声速压气机转子失速工况时流动失稳触发过程研究
10.
Apart from being a low-speed mechanical transmission, but also can be used as a sub-degree turntable determine the final location of the machinery.
除了作为低速传动机械外，也可用作在分度转台时确定最后位置的机械。
11.
At any given element spacing, the minimum stable operating hydrogen injection temperature varied linearly with face coverage.
对于任何给定的单元间距，稳定工作的最低氢喷射温度随喷注面覆盖而线性地变化。
12.
The line speed stability of the designed digital controller keeps in good agreement with the requirements in local well logging, and the workload is also decreased.
所设计的数字控制器的速度稳定性完全满足测井工作需要，降低了劳动强度。
13.
As the operating point crosses over the stability boundary, the chug amplitude disappears.
当工作点越过稳定性边界时，低频不稳定的振幅逐渐消失。
14.
We should keep up our good work with regard to population and family planning and maintain a low birth rate.
继续做好人口与计划生育工作，稳定低生育水平。
15.
By changing these parameters and the Z-directional stiffness of the outer-ring, the stiffness and the damping characteristic of the damper can be varied.
在转子系统支承中引入摩擦阻尼器能够降低支承刚度，从而降低系统的临界转速，避开工作转速。
16.
The growth rate of State owned industries was basically stable.
国有工业增速基本稳定。
17.
An Investigation of Stable Operation Range in Supersonic Axisymmetric Inlet
超声速轴对称进气道稳定工作范围研究
18.
at is concluded that by this process bright Zn plating can be provided with high deposition rate, low cost and reliable quality.
结论是本工艺可镀出全光亮的锌镀层、沉积速度快、成本低,质量稳定。