1.
Analysis of Small End Bushing and Crosshead Pin Failure of Fresh Hydrogen Compressor Connecting Rod in Hydrocracking Unit
加氢裂化新氢压缩机连杆小头衬套与十字头销烧损原因分析
2.
A beam that connects the piston rod to the connecting rod of a reciprocating engine.
十字头连接活塞杆和往复式发动机连杆的横杆
3.
Powder Metallurgy Forging and Cleavaging Technics for Conn-Rod
连杆粉末冶金锻造与连杆大头劈裂技术
4.
a fastener with a tapered threaded shank and a slotted head.
由带螺纹的连杆和槽头组成的扣件。
5.
The crank end of the connecting rod is sometimes called the rod "big end".
连杆的曲轴有时称为“大头”。
6.
Optimize and Design for the Four-Link Structure of the Die Bonder and Motion Simulation Based on the CosmosMotion
基于CosmosMotion的焊头四连杆机构优化设计
7.
A lower, rearward surface, as of the head of a golf club where it joins the shaft.
尾端部位高尔夫球棍头上和杆相连的弯头
8.
Casting technology and optimization of trailer big end based on ProCAST
基于ProCAST的拖车连杆头铸造工艺优化研究
9.
" Bolts, small hexagon head with fit neck and hole through the shank"
GB/T24-1976小六角头螺杆带孔导颈螺栓
10.
" Bolts, small hexagon head with hole through the shank"
GB/T23-1976小六角头螺杆带孔螺栓
11.
A rod or lever transmitting motion in a machine.
连杆机器中传递运动的连杆或杠杆
12.
Connecting rods are re-bushed and bored and/or honed to suit gudgeon pin clearances.
根据与曲轴针连接接缝尺寸要求，重新对连杆小孔上套，镗孔，研磨。
13.
Shape, size, site, color, and inlet and outlet slope of page nexto page.
页连接符号的形状、小、置、色、出箭头。
14.
I am not worth the little finger of either of you.
我连你们两个的小指头都配不上。
15.
A small bone at the junction of the ulna and the carpus.
豌豆骨连接尺骨和腕骨的小骨头
16.
QC Club Overcome the Connection Quality Problem of HRB400-50 Reinforcement Joint
QC小组攻克HRB400-50钢筋接头连接质量
17.
No rails or headboards that can trap a small head.
不要装设可能夹住小脑袋的栏杆或床头板。
18.
Disconnect stabilizer bar links at the axle.
断开车轴上稳定杆连杆。