1.
Shaft Assembly (Male, female, washer, grease….
轴组件（轴，轴套，轴承，油脂。。。）
2.
The Research on Thermal Characteristics of Spindle Components in Milling Center;
铣削加工中心主轴组件热特性的研究
3.
Research on Measuring Dynamic Balancing of Motorcycle Crank Module;
摩托车曲轴组件动平衡检测系统的研究
4.
The Research and Applications of Dynamic Balancing Theory of Motorcycle Crank Module;
摩托车曲轴组件动平衡机理研究及应用
5.
The Research on Vibration Detection and Evaluation Technology of Main Spindle of Machining Center;
机床主轴组件振动检测与评估技术研究
6.
The trunnion assembly is supported by air bearings at the end of each arm and is held in position by brake shoes at each bearings.
耳轴组件的支承是每根臂末端的空气轴承，轴承上的闸瓦起定位作用。
7.
Hub And Bearing Assembly Mounting Surfaces
轮毂轴承组件固定面
8.
Radio frequency and coaxial cable assemblies--Part 2-1: Sectional specification for flexible coaxial cable assemblies
GB/T15866-1995射频同轴电缆组件第2-1部分:柔软同轴电缆组件分规范
9.
Radio frequency and coaxial cable assemblies--Part 3: Sectional specification for semi-flexible coaxial cable assemblies
GB/T16531-1996射频同轴电缆组件第3部分半柔软同轴电缆组件分规范
10.
Radio frequency and coaxial cable assemblies--Part 4: Sectional specification for semi-rigid coaxial cable assemblies
GB/T15867-1995射频同轴电缆组件第4部分:半硬同轴电缆组件分规范
11.
Design of Fillet Parameter of Needle-cage Assembly
滚针轴承保持架组件圆角参数的设计
12.
Modular units for machine tool construction--Multi-spindle heads--Casing and input drive shaft dimensions
GB/T3668.1-1983组合机床通用部件多轴箱箱体和输入轴尺寸
13.
Modular units for machine tool construction--Spindle noses and adjustable adaptors for multi-spindle heads --Dimensions
GB/T3668.10-1983组合机床通用部件多轴箱主轴端部和可调接杆尺寸
14.
Study on Design Method of Cardan Cross-pin Spindles Based on COM/COM+;
基于COM/COM+组件技术的十字轴式万向联轴器设计方法的研究
15.
The hub and bearing assembly does not require removal from the steering knuckle to replace wheel attaching studs in the hub and bearing assembly.
更换轮毂及轴承组件内的车轮固定螺桩无需自转向关节中取出轮毂及轴承组件。
16.
A Pivoting Method for the Portfolio Decision Under the Condition of Not Allowing Short Sales;
限制卖空条件下组合投资决策的转轴方法
17.
The Research about Group Technology Applied in the Shaft Parts' Production
成组技术在轴类零件生产中的应用研究
18.
Design of Three Axis Accelerometer Driver Based on TinyOS
基于TinyOS的三轴加速度传感器驱动组件的设计