1.
Design of Integrated Supercharging Device for Injection Pipe Fatigue Test;
喷油管疲劳试验集成式增压装置的设计
2.
Fuel Injector Line At Injector
在喷油器处的燃油喷油器管线
3.
ejector-type through-tubing too
喷射式过油管下井仪
4.
The oil rushes up the tube and spouts up as a gusher.
石油会沿着钢管上涌，如同自喷井那样喷射出来。
5.
aperture atomizer
喷孔式喷油嘴喷雾器
6.
Oil spouted out from a broken pipe.
油从裂开的管道中喷涌而出。
7.
Design of the Spraying Silicon Sand Production Line of Environmental Protection Type for Cleansing Oil Pipe Surface
环保型喷砂油管净化处理生产线设计
8.
The workman cheered when oil at last gushed from the pipe.
油终于从油管中喷出时，工人们雀跃欢呼。
9.
The Research for Simulation of the PPVI Fuel Injection System on Diesel;
柴油机电控泵管嘴燃油喷射系统仿真研究
10.
Experiment of drying rapeseed by spouted bed with a porous branch rotating draft tube
开孔支管旋转导向管喷动床干燥油菜籽试验
11.
Effect of Entrance and Outlet Position of Common Rail in Electronic-control Diesel Engine on Inject Pressure Fluctuation
电控柴油机共轨管进出油口位置对喷油压力波动的影响
12.
Remove fuel supply line latch clip at injector rail.
拆下喷嘴托杆处之燃油供应管线搭扣夹。
13.
Study on Fuel Injection Control Strategy and Optimization of the Rail for High Pressure Common Rail
高压共轨喷油控制策略及共轨管优化设计研究
14.
Study on Method of Determining Depth about Hydraulic Jetting Sand Perforation With Coiled Tubing
连续油管水力喷砂射孔深度确定方法探究
15.
Application of Retrievable Safety Valves to Jet Pump Production System
投捞式管内安全阀在水力喷射泵采油中的应用
16.
A jetting procedure for the anticorrosion inside the oil pipe by the rotation of a superspeed is used in ChingQing Qilfield
超高速旋转喷涂工艺在油套管内防腐中的应用
17.
Design of Intake of Engine Equipped with Carburetor for EFI Technology of Engine
化油器发动机进气歧管电喷化的设计开发
18.
Numerical simulation on the characteristics of fuel spray pre-pheating and pre-evaporation in evaporating pipe
蒸发管内燃油喷雾预热预蒸特性的数值模拟