1.
Install valve cover (refer to valve cover installation in this section).
安装阀盖（请参阅本节中的阀盖安装）。
2.
Install cylinder head, intake manifold, and exhaust manifold, refer to cylinder head installation in this section.
安装汽缸盖，进气歧管和排气管，请参阅本部分的汽缸盖安装。
3.
I can't fasten the lid on this box.
我无法将箱盖安装在箱子上
4.
Install the distributor cap and wiring.
安装分电盘盖和电线。
5.
Instrument Panel End Cap Remove/Install
仪表板端盖拆卸/安装
6.
Instrument Panel Top Cover Remove/Install
仪表板上盖的拆卸/安装
7.
Install the lower bearing inserts into the main bearing caps.
安装下轴瓦到主轴承盖。
8.
Install Timing case cover (refer to the timing case cover installation in this section).
安装正时箱盖（请参阅本节中的正时箱盖的安装）。
9.
Install the serrated retainers at the ends of the cover.
在盖的末端安装蛇型固定装置。
10.
Install relief valve cover nut and tighten.
安装安全阀阀盖螺母，并加以紧固。
11.
"Finally, door, windows, truck lids, trim item and so on are add to complete the assembly."
最后,再装门、窗、车盖、装饰等,以完成全部安装工作。
12.
Do not remove the sealing caps from a replacement component until it is to be installe
直至安装时，方可拆开替换部件的封盖。
13.
To make and fit two iron blinders for air port in dining saloon.
制作并安装餐厅里两只舷窗铁盖。
14.
Install seat cushion outboard trim cover.
安装座位衬垫外侧饰板盖。
15.
Install secondary cables to distributor cap.
安装辅助电缆至分电盘盖。
16.
Install the bolts attaching the end cap to the front fender.
安装连接末端端盖到前挡泥板的螺栓。
17.
Timing Case Cover Alignment and Seal Installation Tool 6139
正时箱盖对齐和油封安装工具6139
18.
Install pitman shaft and side cover in the housing.
在机座中安装转向摇臂轴和侧盖。