1.
Install the timing chain, crankshaft sprocket and camshaft sprocket with the timing marks aligne
安装正时链、曲轴链轮和凸轮轴链轮，使正时标记对齐。
2.
If chain is not satisfactory, remove camshaft sprocket attaching bolt and remove timing chain with crankshaft and camshaft sprockets.
若正时链不令人满意，则拆下凸轮轴链轮固定螺栓，并拆下曲轴和凸轮轴链轮的正时链。
3.
A camshaft driven by a chain or belt turns in the same direction as the crankshaft.
凸轮轴被链或者带驱动，使其朝着曲轴相同的方向转动。
4.
crankcase cam gear bushing
曲轴箱凸轮传动轴衬套
5.
A Crankshaft Fluctuation Sensor (CKF) is located near the bottom of the timing cover where it generates a signal as the crankshaft timing chain sprocket rotates past it.
曲轴位置传感器安装在定时器壳底部附近，产生一个曲轴定时链轮齿通过的信号。
6.
The main products are sprocket for motorcycle (vehicle)and crank-shaft for general machinery.
目前生产销售的两大类产品为传动链轮和通用汽油机曲轴。
7.
crankshaft fan pulley
曲轴上的风扇皮带轮
8.
The camshaft rotates in phase with the crankshaft, but at half its speed.
凸轮轴和曲轴协调旋转, 但速度仅是曲轴的一半。
9.
Verify Crankshaft—Camshaft Installation—Typical
验证曲轴—凸轮轴安装—典型的
10.
High Speed Grinding with CBN Grit Wheel for Camshaft Manufacturing of Engine
发动机曲轴凸轮轴CBN高速磨削加工
11.
The ratio of the crankshaft to the revolutions of the camshaft is 2∶1.
曲轴的转速与凸轮轴的转速之比是2∶1。
12.
This means that the crankshaft will make two revolutions for every revolution of the camshaft.
这意味着凸轮轴每旋转一次曲轴将旋转两次。
13.
Design of the crankshaft pulley signal plate dedicated CNC milling machine
曲轴皮带轮信号盘数控铣齿专机设计
14.
Structural Modal Analysis for the Crankshaft/flywheel component of a 4-cylinder IC Engine
四缸内燃机曲轴-飞轮组结构模态分析
15.
Research on Modeling of Impeller Meridian Passage Based on Bezier Curves
基于Bezier曲线叶轮轴面流道造型研究
16.
Remove the camshaft retaining bolt and remove the sprockets and chain as an assembly.
拆去凸轮轴固定螺栓，并拆去作为一个总成的链轮和链条。
17.
But a camshaft driven directly by the crankshaft gear turns in the opposite direction.
但是凸轮轴被曲轴齿轮直接驱动，其将在相反方向上转动。
18.
Analysis of the Cylindricity Tolerance and Press Mounting Curves of Axle Wheel Seat and Wheel Hub Bore
关于车轴轮座、车轮轮毂孔的圆柱度公差和压装曲线分析