1.
Stainless steel stuffing box hardware is standard (ie. bolts, gland studs, nuts, washers).
标准的金属密封不锈钢填料箱（如螺栓、填料压盖螺栓、螺母、垫圈）。
2.
Equally distributed gland bolts provide uniform compression of packing.
均匀分布的压盖螺栓为填料提供均匀的压力。
3.
Remove the relief valve cover bolts while holding the cover down.
边压住阀盖，边拆卸安全阀阀盖螺栓。
4.
cap-and-pin type insulator
帽盖穿心螺栓式绝缘子
5.
Gland Eye Bolts: Eyebolts swing aside for ease in repacking the stuffing box.
压盖有眼螺栓：有眼螺栓可以从旁边旋起，使得填料函的填料更换更加容易。
6.
Gland– two piece, self-aligning gland eliminates cocking. Swing out bolting facilitates maintenance.
(8) 压盖–两件式，自行调整压盖，不需要配置压簧杆。便于维护的转位式螺栓。
7.
Caution: If cover will not press flat against body, stem assembly is crooked and damage can result. Re-align stem and cover before bolts are inserted.
警告：如果阀盖不压平在阀体上，阀杆就可能扭曲和损坏。在插入螺栓之前，重新对齐阀杆和阀盖。
8.
The circular ring joint bonnet seal has proven to be the best bolted high pressure bonnet joint available.
这种圆形环状连接阀盖密封经过实践证明是目前最好的螺栓高压阀盖连接。
9.
Install the bolts attaching the end cap to the front fender.
安装连接末端端盖到前挡泥板的螺栓。
10.
Analysis on Fatigue Cracking of Cylinder Cap Bolt
缸盖螺栓接触损伤引发疲劳开裂分析
11.
Analysis on Fatigue Life to the Air Cylinder Bolt in Super High Pressure Compressor
超高压压缩机气缸螺栓疲劳寿命评估
12.
"Bolts,screws & nuts"
"螺栓,螺丝及螺帽"
13.
The valve cover shall be held in place through the use of a single grooved style two-bolt coupling.
阀盖应该通过单个沟槽状双螺栓联结器固定住。
14.
Bolted on, top entry single access cover for ease of maintenance.
螺栓固定，顶部进入的唯一检修盖，便以维护。
15.
Sweat Solder adapter with Cover Tube and Cast Set Screw Wall Flange
焊接焊料适配器含盖管和铸造固定螺栓墙法兰
16.
The cylinder head is attached to the block with high-tensile steel studs.
气缸盖与气缸体用高强度的钢螺栓缚连结。
17.
Using a wrench, place the bolts back into the cover and tighten.
用扳手将螺栓放回到阀盖上，并加以紧固。
18.
The Fuzzy Reliability Design about the Bolt-joint Set of Engine Bonnet
内燃机缸盖螺栓组联接的模糊可靠性设计