1.
Research on disassembly model and disassembly sequence planning based on modularization
基于模块化的拆卸模型及拆卸序列规划研究
2.
Based on analyzing feature of the existed disassembly models, disassembly and recycling model based on“ Hybrid Graph” is proposed.
在分析现存拆卸模型的基础上,提出基于“混和图”的产品拆卸回收分析模型。
3.
Module Unload: %s.
模块卸载: %s.
4.
Door Module Remove/Install
车门模组拆卸/安装
5.
Remove the door module from the trim panel.
从饰板上拆卸车门模组。
6.
Structure Optimization and Process Simulation of Chain Unloader
链式卸船机结构优化及卸料过程的模拟
7.
This paper studied the disassembling sieve in disassembly graph model systemically.
系统地研究了构造拆卸图模型过程中的可拆卸性筛子。
8.
Disassembling sieve based-on polychromatic sets has the advantages of higher formalization level and easily programming.
该研究结果保证了拆卸图模型和拆卸过程规划结果的正确性。
9.
DISCONNECT THE SEAT BELT CONTROL MODULE.
拆卸座位安全带控制模组。＊＊
10.
Push Button Module Remove/Install
按压按钮模组的拆卸/安装
11.
Product information model for disassembly and recycling is developed.
建立面向拆卸回收的产品信息模型。
12.
The molds can be changed according to the suitable insole size.
模具装卸方便，以利各种尺寸中底定型。
13.
Numerical Simulation of Rock Mass Unloading Damage and Its Engineering Application;
岩体卸荷损伤数值模拟及其工程应用
14.
Stochastic Network Model for Disassembly of Discarded Products;
装配式产品拆卸的随机网络模型研究
15.
Failure characteristics and constitutive model of rock under unloading condition
岩石卸荷破坏的变形特征及本构模型
16.
A Product Selective Disassembly Model Based on Hybrid Directed Graph
面向目标拆卸的产品复合有向图建模
17.
The model analysis of motorized wheel dump truck based on ANSYS
ANSYS的电动矿用自卸车有限元模态分析
18.
An Analysis on the Container Handling Technology Models in the Middle and Small Container Terminals
中小型集装箱码头装卸工艺模式分析