1.
Plug the in-vehicle temperature sensor wire harness connector into the instrument panel wire harness.
插车内温度感知器线束接头进仪表板线束接头。
2.
Unplug the wire harness connector between the clockspring and the instrument panel wire harness, located near the base of the steering column.
拔去计时弹簧和仪表板线束之间，位于转向柱基底附近的线束接头。
3.
Remove the screws that secure the instrument panel wire harness trough to the airbag rear mounting bracket.
拆去固定仪表板线束槽到安全气囊后固定托架的螺丝。
4.
Route the vacuum harness through the instrument panel opening and reinstall the vacuum harness push-in retainer.
将真空线束穿过仪表板口并重新安装真空线束推入扣件。
5.
Disconnect the vacuum harness connector from the back of the heater-A/C mode control switch on the control panel.
从控制仪表板上的空调暖气模式控制开关上断开真空线束接头。
6.
INSTRUMENT PANEL 22-WAY CONNECTOR
仪表板２２－路接头
7.
INSPECT THE INSTRUMENT CLUSTER CIRCUIT BOAR
检查仪器仪表组电路板。
8.
instrument cluster
仪表组（仪表板上所装的各种组合仪表）
9.
Remove left cowl side trim panel.
拆下左仪表板侧装饰板。
10.
Constrained metal-plate lens antenna
约束金属板透镜天线
11.
INSTRUMENT PANEL 10-WAY CONNECTOR (AT BCM)
仪表板１０－路接头（在ＢＣＭ）
12.
Instrument Panel End Cap Remove/Install
仪表板端盖拆卸/安装
13.
Instrument Panel Top Cover Remove/Install
仪表板上盖的拆卸/安装
14.
emergency panel lights switch
仪表板应急照明电门
15.
PANEL/DEMIST DOOR AND LEVER
仪表板/除霜器门和连杆
16.
Beamsplitter Testing Using Michelson Interferometer
用迈克尔逊干涉仪检验分束板的性能
17.
parallel plate viscosimeter (spread-o-meter)
油墨特性线的平行板粘度仪(铺展仪)
18.
Remove the trim panel and waterdam from door inner panel.
从内部仪表板拆卸饰板和挡水器。