1.
Design Of Intake Manifold For 1.1L Engine
1.1L前驱动微型汽车发动机进气歧管开发
2.
Design of Intake of Engine Equipped with Carburetor for EFI Technology of Engine
化油器发动机进气歧管电喷化的设计开发
3.
Research on Some Key Techniques of Manifold Absolute Pressure Sensor in Vehicle Motor
汽车发动机进气歧管压力传感器关键技术的研究
4.
The Research on the Performance of Timed Manifold Injection Hydrogen-Fueled Engine;
进气歧管喷射式氢气发动机性能研究
5.
Vibration Test Failure Analysis on Engine Plastic Intake Manifold and Improvement Study
发动机塑料进气歧管振动试验失效分析与改进研究
6.
If the engine backfires, the sudden pressure in the intake manifold forces the valve back.
如果发动机回火,进气歧管骤增的压力就迫使阀门向后移动。
7.
When the engine is shut off, the intake manifold cools and a slight vacuum forms as a result.
这是因为当发动机熄火时,进气歧管冷却而产生轻微的真空。
8.
Optimization Design of Engine Exhaust Manifold Based on Finite Element Analysis
基于有限元分析的发动机排气歧管优化设计
9.
CFD & FEA coupling analysis application in exhaust manifold analysis
某发动机排气歧管流固耦合分析的应用
10.
manifold (intake and exhaust) for internal combustion, aircraft engines
歧管(进气和排气),航空内燃机用
11.
On a typical in-line six-cylinder engine the carburetor is located on the intake manifold between cylinder 3 and 4.
在标准的六缸直列式发动机上,化油器被设置在进气歧管上3号和4号缸之间。
12.
Numerical Simulation of the Backflow in the Intake Manifold on 4110 Diesel;
4110柴油机进气歧管进气回流数值仿真及优化
13.
The gases pass into the exhaust manifold.
这些废气进入排气歧管。
14.
Install the intake manifold (refer to Group 11, Exhaust System and Intake Manifold).
安装进气歧管(见单元11-排气系统和进气歧管)。
15.
Remove the intake manifold (refer to Group 11, Exhaust System and Intake Manifold).
拆下进气歧管(见单元11-排气系统和进气歧管)。
16.
Loose install EGR tube and EGR valve to intake manifol
将EGR管和EGR阀装入进气歧管,并保持松动。
17.
Remove intake manifold bolts.
拆下进气歧管螺栓。
18.
Research on Design Method of Plastic Air Intake Manifold Cavity for Gasoline Engine;
汽油机塑料进气歧管型腔设计方法研究